Epson PowerLite 822p Product Information Guide - Page 12
Replacing the Lamp, Warning - replacement lamps
View all Epson PowerLite 822p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
PowerLite 822p/83c Projector You can remove the air filter to clean both sides. Vent Air filter If the dirt is difficult to remove or if the filter is torn, replace it. Contact your dealer or call Epson at (800) 463-7766 to obtain a new one (part number V13H134A13). 3. If you need to clean or replace the filter, slide it out, as shown. 4. Align the new filter carefully and slide it in until it clicks into place. Replacing the Lamp The projection lamp typically lasts for about 3000 hours of use (in high brightness mode) or 4000 hours (in low brightness mode). It is time to replace the lamp when: ❏ The projected image gets darker or starts to deteriorate. ❏ The lamp light is flashing orange. ❏ The message Replace the Lamp appears on the screen when the lamp comes on. To maintain projector brightness and image quality, replace the lamp as soon as possible. Note: You can check to see how many hours the lamp has been used through the Info menu. Contact your dealer or call Epson at (800) 463-7766 for a replacement lamp. Request part number V13H010L42. Warning: Let the lamp cool before replacing it. If the lamp breaks, handle the shards carefully to avoid injury. Follow these steps to replace the lamp: 1. Press the P Power button twice to turn off the projector. When you hear the projector beep twice, unplug the power cord. 2. If the projector has been on, allow it to cool down for at least an hour (or until the lamp is cool). 3. Use the screwdriver included with the replacement lamp (or a #2 Phillips-head screwdriver) to loosen the screw holding the lamp cover on top of the projector. 4. Slide the cover out, then lift it off. Note: Air filters contain polycarbonate, ABS resin, and polyurethane foam. Dispose of used air filters according to local regulations. 12 - PowerLite 822p/83c Projector 3/08