Epson PowerLite 825 Operation Guide - EasyMP Monitor v4.40 - Page 38
Mail notification function settings, Procedure
View all Epson PowerLite 825 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Mail notification function settings Mail notification function settings The mail notification function can be used to send corresponding notification messages to a preset e-mail address when a projector that is connected to the network assumes a certain status, or if it experiences a problem or warning. By using this function, the operator can be notified of a projector's status or problems even when the operator is in a different location from the projectors. q • Up to three addressees (destinations) can be registered and messages can be sent to all of them at once. • If a critical problem develops with a projector which causes it to suddenly stop working, it may not be possible for the projector to send a message notifying an operator of the problem. • If Standby Mode is set to Communication On (or Network On) or Network Monitoring is set to On in the projector configuration menus, you can monitor the projector even when it is in standby mode (when its power is turned off). s Projector's User's Guide • On some projectors, the mail notification function can be set in the configuration menu. When notification messages are set to be sent in the projector's configuration menu, both the settings in the configuration menu and settings made on EasyMP Monitor are functional. • Detectable status with the mail notification function differs depending on the projector you are using. Procedure A Select "Mail notification function" from the Tool menu. 38 B The Set mail notification function window will be displayed. Make the necessary settings while referring to the table below. Mail notification function SMTP server IP address Sender mail address Recipient mail address 1 Recipient mail address 2 Recipient mail address 3 Set to On to use the mail notification function. Enter the IP address of the SMTP server. Up to a maximum of 255 bytes can be entered. When you change a port number of the SMTP server, specify this port number. The default value is "25". You can enter a valid number from 1 to 65535. Enter the sender's e-mail address. Up to a maximum of 255 bytes can be entered. Specify the destination addresses for the notification e-mail. Up to three destinations can be set. Up to a maximum of 255 bytes can be entered.