Epson PowerLite 82c Product Information Guide - Page 10
Using the Remote Control, Using the Remote Control as a Wireless Mouse, Mouse - replacement
View all Epson PowerLite 82c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Epson PowerLite 62c/82c Projector Power light Red Lamp light Flashing red Temp light Flashing red Red Off Flashing red Red Flashing Off red - Flashing Off orange Red Off Red Flashing Off red Flashing orange Orange Off Off Flashing Off Off green Green Off Off Flashing Off Off orange Description The projector has an internal error. Turn it off and unplug it. Contact Epson for help. There is a problem with the fan or a sensor. Turn off the projector and unplug it. Contact Epson for help. The lamp is burned out, broken, or not installed correctly, or the lamp cover is open. Close the cover or replace or reseat the lamp, if necessary, as described on page 12. Replace the lamp with a new one as soon as possible; see page 12 for instructions. If you continue to use the lamp, it may break. The projector has overheated and turned itself off. Let it cool for about five minutes, then turn it back on. Make sure there is plenty of space around and under the projector for ventilation. Also clean the air filter and air exhaust vents. If it continues to overheat, you may need to replace the air filter. The projector is too hot. Make sure the temperature surrounding the projector does not exceed 95 °F (35 °C) and there is plenty of space around and under the projector for ventilation. Clean the air filter and air vents, if necessary. The projector is in standby or sleep mode. You can unplug it or press the P Power button to turn it on. The projector is warming up. Wait for the image to appear. The projector is operating normally. The projector is shutting down. Wait for the light to stop flashing and remain orange before unplugging it. Using the Remote Control The remote control lets you access the projector's features from anywhere in the room-up to 20 feet away. (This distance may be shorter if the remote control batteries are low.) The projector may not respond to remote control commands in these conditions: ❏ You are not within 20 feet (6 meters), or not within 30° to the left or right of the front or rear sensor or 15° above or below it ❏ The battery is weak or not installed correctly ❏ Ambient light is too bright ❏ A fluorescent light is shining into the infrared receiver ❏ A strong light source (such as direct sunlight) is shining into the infrared receiver ❏ Other equipment emitting infrared energy is present (such as a radiant room heater) Using the Remote Control as a Wireless Mouse When you use the remote control as a wireless mouse, you can control your computer or click through slideshow-style presentations (such as PowerPoint) from up to 20 feet (6 meters) away. To control your computer with the remote, make sure you have connected your computer to the projector with a USB cable. ❏ To display the mouse pointer, press the Pointer button. Left-click or double-click Move the pointer ❏ To move the pointer on the screen, aim the remote at the screen and use the pointer button. ❏ To click (or left-click), press the Enter button. ❏ To double-click, press the Enter button twice. ❏ To right-click, press the Esc button. ❏ To click and drag, press down and hold the Enter button and use the pointer button to drag the pointer. Display the pointer Right-click 10 - Epson PowerLite 62c/82c Projector 9/05