Epson PowerLite Pro Cinema 6010 Quick Setup - Page 1

PowerLite® Pro Cinema 6010 Quick Setup Before using the projector, make sure you read the safety instructions in the online User's Guide. Choose a location Keep the projector level and place it at a height where its lens is centered between the top and bottom of the screen. If this isn't possible, use the lens shift dials and keystone correction buttons to reposition the image (see "Adjust the image"). In order to view 3D images correctly, 3D glasses must be worn within proper range of the projector. Use the image below to determine the ideal distance for 3D projection (the shading represents the 3D viewing area): Turn on your equipment 1 Turn on your video source or computer. 2 Plug in the projector. 3 Turn on the power switch on the back of the projector. 4 Press the power button on the projector or On button on the remote control. The power light flashes blue, and then stays on. 60º 16.5 ft (5 m) 13 ft (4 m) Use the optional external 3D emitter if the projector is located over 16.5 feet (5 m) from the viewing area. See "Optional accessories" on the back of this sheet for ordering information, and the online User's Guide for more information on where to place your projector. Connect the projector Choose from the following connections. See the sections below or the online User's Guide for details. Video Device Connect up to 4 video devices and use the Source buttons on the remote control or the button on the projector to switch between them. HDMI cable RCA Video cable Component video cable Computer HDMI cable VGA cable Monitor Port Connect one end of a VGA cable to the projector's PC port, and the other end to your computer's monitor port. If you are using a laptop, switch it to external display (see "Troubleshooting"). You can also connect an audio cable. HDMI Port Connect one end of an HDMI cable to the projector's HDMI port and the other end to an HDMI port on your computer. Note: To shut down the projector, press the power button on the projector twice or the Standby button on the remote control, then unplug it. You don't have to wait for the projector to cool down. 5 The default language of the menu system is English. To select another language, press the Menu button on the remote control. Select Extended and press Enter. Select Language and press Enter. Select your language and press Enter. Press the Menu button to exit the menu system. Adjust the image 1 If you don't see an image, press the Source buttons on the remote control or the button on the projector to select the image source. Note: If you still see a blank screen or have other display problems, see the troubleshooting tips on the back of this sheet. 2 To raise the image, adjust the front feet as shown below. 3 If necessary, turn the horizontal and vertical lens shift dials to adjust the image position and center it between the top and bottom of the screen. 4 Turn the zoom ring to reduce or enlarge the image. *412203300* *412203300*