Epson Pro L1500U Users Guide - Page 287
FCC Compliance Statement, Symbol, Approved Standards, Description, Parent topic
View all Epson Pro L1500U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 287 highlights
No. Symbol 23 Approved Standards IEC60417 No. 5266 Description Standby, partial standby To indicate that part of the equipment is in the ready status. 24 ISO3864 Caution, movable parts IEC60417 No. 5057 To indicate that you must keep away from movable parts according to protection standards. Parent topic: Notices FCC Compliance Statement For United States Users This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio and television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. WARNING The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC Certification or Declaration of this device and may cause interference levels which exceed the limits established by the FCC for this equipment. It is the responsibility of the user to obtain and use a shielded equipment interface cable with this device. If this equipment has more than one interface connector, do not leave cables connected to unused interfaces. Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment. 287