Epson ProSense 57 Quick Start - Page 1
Epson ProSense 57 Manual
View all Epson ProSense 57 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
GPS Running Watch 57 Quick Start Guide Make sure to read the Notices sheet and online User's Guide before using the product to ensure safe use. Buttons ProSense57_QSG_E_CPD54150_2pages.indd 1 Back Start/Stop Up Enter Down Wearing Your Watch Wear the product snugly around your wrist as shown. Tighten the watch if your pulse is not measured correctly while exercising. 1 Charging the Watch Use the included USB charging clip to charge the watch. 1 Connect the USB charging clip to the watch. 2 Setting Up the Watch and App The Settings screen appears on the watch after you remove the USB charging clip. 1 On the watch, select your language and press Enter. 3 Download and install the Epson View app from your smartphone's app store. 4 Launch the Epson View app and create an account or log in. After you finish this process, the initial Settings screen appears on your smartphone. 2 Select Set by Phone and press Enter. 5 Note the code that appears on the watch. 3 Using Your Watch Selecting a Workout Mode 1 Press down on the Time screen to display the workout mode screen. The following workout modes are available: Run Walk Treadmill 6 Select ProSense 57 from the list on your smartphone, then follow the instructions to pair your watch and your phone. Note: You can press Start/Stop on the Time screen to quickly start a run. 3 Press Start/Stop while outdoors with no obstacles overhead to start GPS calibration. Note: If you see the message below, do one of the following: • Move to an area with no obstructions overhead and then press back to restart GPS calibration. • Press Enter to start the workout. Distance traveled will be estimated until the GPS signal is fully acquired. Note: You can press Enter during a workout to start and record a new lap. Press up or down during a workout to change the measurements that appear. See the online User's Guide for more information. 2 Connect the USB cable to your PC or the optional AC adapter. Make sure the watch is fully charged before you remove the clip. Note: You can also use a PC to configure the watch or you can configure the watch on its own. See the online User's Guide for more information. Note: Once you have completed the initial setup, you can use the Epson View app to customize the workout screens, change settings, and link to third-party fitness apps. The Time screen appears on the watch when the process is complete. Note: You can pair the watch with your smartphone at any time by selecting My Watch in the Epson View app. 2 Press up or down to select the desired activity. You can start your workout when the Measurement screen appears. For increased GPS accuracy, wait at least 15 minutes before starting your workout. You only need to perform this extended GPS calibration the first time you use the watch or if you do not use it for a few months. Starting a Workout Press Start/Stop on the Measurement screen to start a workout. 7/14/17 2:11 PM