Epson SP7900HDR Quick Reference Guide - Page 9
Replacing Printer Parts continued, Replacing the Maintenance Tank
UPC - 010343872752
View all Epson SP7900HDR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Replacing Printer Parts (continued) 6 Carefully remove the cutter. Warning: The blade is sharp. Be careful when removing it. 7 Insert the new cutter. Make sure the cutter pin goes into the hole. 11 Run the cutter adjustment from the Maintenance menu using the control panel. Replacing the Maintenance Tank The Pro 7900 has one maintenance tank (on the right side) and the Pro 9900 has two (one on either side). You need to replace the maintenance tank (part # C12C890191) when you see MAINTENANCE TANK FULL on the LCD, the icon has an X, and the printer won't print. 1 If you have the Pro 9900, check the LCD to determine which tank needs to be replaced (left or right). Note: The printer will not print if one of the maintenance tanks is full. On the Pro 9900, the right tank is used more than the left. To maximize tank life, you can switch the tanks. 2 Turn off the printer. 8 Tighten the screw using a cross-head screwdriver. 3 Pull out the maintenance tank as shown. 9 Align the cutter cover, then press it in until it snaps into place. Caution: Do not tip the tank or ink may spill out. 4 Place the used tank in the plastic bag included with the new tank and dispose of it carefully. 5 Insert the new tank. 10 Press OK to finish the replacement procedure. The cutter moves back to the home position. 8