Epson Stylus COLOR 800N Product Information Guide - Page 5

EPSON Stylus COLOR 800N Network Software Novell Netware 2.x, 3.x, or 4.0 (Bindery Emulation Mode) EtherTalk (AppleTalk) DLC lpr, ftp over TCP/IP protocol NetBEUI NetBIOS over TCP/IP protocol Environmental Temperature Humidity Operation 50 to 95 °F (10 to 35 °C) Storage -4 to 140 °F (-20 to 60 °C) 1 month at 104 °F (40 °C) 120 hours at 140 °F (60 °C) Operation 20 to 80% RH Storage* 5 to 85% RH *stored in shipping container Safety Approvals EMC FCC part 15 subpart B class B Reliability MTFB 10,000 hours (power on hours) Control Panel black cleaning button color cleaning button paper out light black ink out light color ink out light load/eject button power button power light The four lights on your printer's control panel show the printer's status and alert you to problems like paper jams. S S B A B A P P S B A P S B A When the paper light flashes, paper is jammed in the printer. Turn off the printer and gently pull out all jammed paper. Then press the E load/eject button. When the paper light comes on, your paper ran out or is incorrectly loaded. Load paper in the feeder and then press the E load/eject button. When an ink light flashes, your ink supply is low. Make sure you have a replacement cartridge. When an ink light comes on, you need to replace the ink cartridge. When the power light flashes, the printer is receiving a print job or performing a maintenance operation. When the power and paper lights flash and the other lights are on, your printer has a carriage error. When all the lights flash, your printer may have an internal error. Testing the Printer You can run a self test to determine whether the problem comes from the printer itself or the computer. t If the results are satisfactory, the problem lies in software settings, the interface cable, or your computer. t If the self test does not print correctly, you have a problem with your printer. Follow these steps to run the test: 1. Make sure both the printer and computer are turned off. 2. Disconnect the interface cable from the printer. 3. Make sure paper is loaded in the feeder. 4. Press the E load/eject button and hold it down while you press the Ppower button. Continue to hold the buttons until the Ppower light starts to flash. The printer prints a nozzle check pattern and samples of fonts and colors. 5. To end the test, turn off the printer. 10/97 EPSON Stylus COLOR 800N - 5