Epson Stylus CX4450 Quick Reference Guide - Page 26

Problems and Solutions Check the solutions below if you're having trouble using your Epson Stylus CX4400 Series all-in-one. Printing and Copying Problems ■ If one of the Copy buttons don't work, your all-in-one may be in sleep mode. Press the button again to copy. ■ Make sure your original is positioned in the front right corner of the glass. If the edges are cropped, move your original away from the edges slightly. ■ Make sure your paper is loaded short edge first and is positioned against the right side with the edge guide against its left side. Don't load paper above the arrow mark inside the edge guide. ■ Make sure the paper size settings are correct for the paper you loaded. Paper Feeding Problems ■ If paper doesn't feed, remove it from the sheet feeder. Flip through the stack to separate the sheets a little. Then reload the paper against the right side, and slide the edge guide against the paper (but not too tightly). ■ Do not load too many sheets at once-up to 20 sheets of photo paper and 80 sheets of plain paper. Load other special papers one sheet at a time. ■ If paper is jammed, follow these steps: 1. Press one of the x Copy buttons to eject the jammed paper. 2. If paper is still jammed, gently pull it out from the output tray or sheet feeder. 3. If the paper is stuck inside, press the P On button to turn it off. Then open the scanner, remove the jammed paper and torn pieces, close the scanner, and turn the all-in-one back on. 4. If the b paper light is still flashing, press the P On button and the x Color Photo button to clear the error. 26 Solving Problems