Epson Stylus NX530 Start Here - Page 2
Load paper - ink
View all Epson Stylus NX530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
6 Press each cartridge down until it clicks. 3 Slide the edge guide to your paper size. 7 Close the cartridge cover. Press down until it clicks. Then lower the scanner unit and press OK. Letter-size 4 Load paper against the edge guide with the glossy or printable side facedown. N ote: Make sure the paper is loaded against the edge guide and not sticking out from the end of the cassette. 8 Wait while the ink delivery system primes. Priming takes about 5 minutes. N ote: Your printer ships with full cartridges and part of the ink from the first cartridges is used for priming the printer. C aution: Don't turn off the printer while it is priming or you'll waste ink. 9 When you see this menu on your product's LCD screen, do not make a selection yet. Continue with the instructions in the following sections to load paper in your product and install software. 5 Slide the edge guides against the edges of the paper, but not too tightly. 5 Load paper 1 Pull out the paper cassette at the bottom of the printer. 2 Slide the edge guides to the sides of the cassette. 6 Keep the cassette flat as you insert it. Note: The paper may slide forward slightly as you insert the cassette. This is normal. 7 Extend the output tray and flip up the paper stopper. Note: Do not flip up the paper stopper if you're using legal-size paper.