Epson Stylus Pro 5000 Product Information Guide - Option - Page 3
INTERFACES, Host Interfaces, Printer Interface, CONROL PANEL MENUS - errors
View all Epson Stylus Pro 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
RIP Station 5000 Interfaces Host Interfaces Parallel Port Parallel port connector pin assignments Pin Signal I/O Pin Signal I/O 1 Strobe I 19 Ground - 2 Data 1 I/O 20 Ground - 3 Data 2 I/O 21 Ground - 4 Data 3 I/O 22 Ground - 5 Data 4 I/O 23 Ground - 6 Data 5 I/O 24 Ground - 7 Data 6 I/O 25 Ground - 8 Data 7 I/O 26 Ground - 9 Data 8 I/O 27 Ground - 10 ACKNLG O 28 Ground - 11 Busy O 29 Ground - 12 PE O 30 Ground - 13 Selectout O 31 Init I 14 Autofeed I 32 Error O 15 NC - 33 Ground - 16 Ground - 34 NC - 17 Chassis-ground - 35 +5V - 18 NC - 36 Selectin I Ethernet Protocols EtherTalk IPX/SPX TCP/IP PAP Server (Ethernet Phase 2) Novell® IPX/SPX RFC 1179, Berkeley LPR Protocol Ethernet Interfaces Ethernet 10/100BaseT connector pin assignments Pin Signal 1 TXD+ 2 TXD- 3 RXD+ 4 NC I/O Pin Signal I/O O5 NC - O6 RXD- I I 7 NC - -8 NC - Ethernet 10/Base5 connector pin assignments Pin Signal I/O Pin Signal I/O 1 Chassis-ground 9 CD- I 2 CD+ I 10 TXD- 0 3 TXD+ O 11 NC - 4 NC - 12 RXD- I 5 RXD+ I 13 PWR - 6 PWR-return I 14 NC - 7 NC - 15 NC - 8 NC - Printer Interface Parallel printer port connector pin assignments Pin Signal 1 Strobe 2 Data 1 3 Data 2 4 Data 3 5 Data 4 6 Data 5 7 Data 6 8 Data 7 9 Data 8 10 ACKNLG 11 Busy 12 PE 13 Selectout I/O Pin Signal I/O I 14 Autofeed I I/O 15 Error O I/O 16 Init I I/O 17 Selectin I I/O 18 Ground - I/O 19 Ground - I/O 20 Ground - I/O 21 Ground - I/O 22 Ground - O 23 Ground - O 24 Ground - O 25 Ground - O Control Panel Menus When the RIP is started, the following message appears: For software update or setup, press any key. If a key is pressed, the following menu appears: Setting Run Setup Install Software Format Disk Options See Setup menu table on page 4. From parallel port From SCSI port Standard Description See Setup menu table on page 4. Allows the software to be updated, either via the parallel port (using the copy command on a PC) or via the SCSI port (using an external SCSI CD-ROM drive). For authorized service technicians only. High level format, clears only FAT. Full Low level, then high level. Full & Verify After full format, reads and compares all sectors. Upgrade Flash __ Flash Info __ For authorized service technicians only Updates the software in the Flash ROM. For authorized service technicians only. Shows the current version of Flash ROM. 3/98 RIP Station 5000 - 3