Epson Stylus Pro 9880 UltraChrome Printer Guide - Page 17
Chap 1-Setting Up the Printer, Unpacking and Assembling the Epson Stylus Pro 7880
View all Epson Stylus Pro 9880 UltraChrome manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
19 Chapter 1: Setting Up the Printer This chapter includes the following information: • Unpacking and assembling the Pro 7880 and Pro 9880 • Connecting the power cord • Installing ink • Connecting to your computer and a network • Installing the printer software for Macintosh or Windows • Updating the printer firmware • Configuring the printer for a network Unpacking and Assembling the Epson Stylus Pro 7880 WARNING: Two people are required to unpack and set up the printer. Follow these steps to assemble your printer and its stand. (If you have the Epson Stylus Pro 9880, see page 29 instead.) Before you begin, make sure you have sufficient space to set up and use the printer. The following illustration shows the minimum space required for using the Epson Stylus Pro 7880: Note: When choosing a place for the printer, leave adequate room for easy access and ventilation. Avoid locations subject to direct sunlight, excessive heat, moisture, or dust. Also avoid locations near potential sources of electromagnetic interference, such as loudspeakers, cordless phones, TVs, or air conditioners. 6 in. (15.2 cm) 24 in. (61 cm) 12 in. (30 cm) 8 in. (20.3 cm) You will also need floor space of approximately 8 × 8 feet (2.4 × 2.4 m) to assemble the printer and stand. 19