Epson Stylus Scan 2500 Product Information Guide - Page 2

EPSON Stylus Scan 2500 System Requirements Windows® t An IBM® compatible PC with at least a 486/66 MHz processor (Pentium® processor recommended) t Microsoft® Windows 95 or 98 t At least 16 MB of RAM (32MB or more recommended) t At least 50MB of free hard disk space (100MB recommended) t VGA or better display adapter and monitor (24-bit color recommended) t Double-speed (2x) CD-ROM drive for installing the software (quad-speed [4x] or faster recommended) for installing the software Your system should also have one of the following interfaces (USB recommended): t Windows 98 only: Available USB port or hub connection, with shielded USB "AB" interface cable, from Series A (computer) to series B (EPSON Stylus Scan), up to 6.5 feet (2 m) long* t Windows 95 or 98: Available parallel port with a highspeed, bidirectional, IEEE-1284-compliant parallel cable (6 to 10 feet long).The cable must have a D-SUB, 25-pin, male connector for your computer and a 36-pin, Centronics® compatible connector for the Stylus Scan.** Caution: Using an improperly shielded USB cable-especially a cable more than 6.5 feet long-may cause the Stylus Scan to malfunction. Notes: * If you're using a USB connection, Windows 98 must be preinstalled on your system-not an upgrade from Windows 95. * If you're using a USB hub, use only a first tier hub (the hub closest to the host computer). ** The EPSON Stylus Scan must be connected to a built-in parallel port (LPT 1 only). It cannot be used with a switch box or pass-through port (for example, on a Zip drive). Macintosh® t iMac® series or other Macintosh computer with built-in USB port t Mac OS 8.1 or later (OS 8.5 or later recommended) t At least 32MB of available memory (64MB recommended) t At least 50MB of free hard drive space (100MB recommended) t VGA or better monitor (24-bit color recommended) t Double-speed (2x) CD-ROM (quad-speed [4x] or faster recommended) for installing the software t Available USB port or hub connection, with shielded USB "AB" interface cable, from Series A (computer) to Series B (EPSON Stylus Scan), up to 6.5 feet (2 m) long Note: If your iMac is running Mac OS 8.1, you need to install the iMac Update 1.0 before installing the EPSON Stylus Scan software. If your iMac is running Mac OS 8.5 or 8.51, Apple recommends that you install iMac Update 1.1. These updates are available online from Apple at http:// swupdates.info.apple.com. Contact Apple if you have problems installing them. Specifications Mechanical Paper feed method Friction Paper path Sheet feeder, rear entry Sheet feeder capacity About 100 sheets at 17 lb (64 g/m²) paper Dimensions Storage Width: 20.4 inches (517 mm) Depth: 20.8 inches (529 mm) Height: 11.8 inches (300 mm) Weight Printing Width: 20.4 inches (517 mm) Depth: 22.6 inches (575 mm) Height: 11.8 inches (300 mm) 26.5 lb (12 kg) without the ink cartridges Printing Printing method Nozzle configuration Resolution Print direction Control code Input buffer On-demand ink jet Monochrome (black) 144 nozzles Color (cyan, magenta, yellow) 144 nozzles (48 [each color] × 3) Maximum 1440 dpi × 720 dpi Bidirectional with logic seeking ESC/P raster EPSON Remote 64 KB 3 - EPSON Stylus Scan 2500 9/99