Epson SureColor F6200 Network Guide - Page 32

Unable to start EpsonNet Config with Web Browser. - - 44

Get Epson SureColor F6200 PDF manuals and user guides View all Epson SureColor F6200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

The message "EpsonNet Config cannot be used because no network is installed." appears when you start EpsonNet Config. Cause Both TCP/IP and IPX/SPX are not installed on the computer. TCP/IP is installed on the computer, but its IP address is not set correctly. What to do Install the TCP/IP or IPX/SPX protocol. Set a correct IP address for the computer. The message "Could not complete communicating configuration data" appears when you send settings to the network interface. Cause This may happen when using a dial-up router. What to do Run Command Prompt from the computer on which EpsonNet Config is installed, and then enter the following command: Format: >ROUTE_ADD_the IP address of the network interface_ the IP address of the computer (the underscore represents one space) Example: >ROUTE ADD 192.168.192.168 22.33.44.55. Unable to start EpsonNet Config with Web Browser. Cause You have not set the IP address for the network interface. What to do Set the IP address for the network interface using EpsonNet Config for Windows, or the printer's control panel. You can check the IP address on a status sheet. See the EpsonNet Config User's Guide. Troubleshooting 32

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
Troubleshooting
32
The message “EpsonNet Config cannot be used because no
network is installed.” appears when you start EpsonNet Config.
The message “Could not complete communicating configuration
data” appears when you send settings to the network interface.
Unable to start EpsonNet Config with Web Browser.
Cause
What to do
Both TCP/IP and IPX/SPX are not
installed on the computer.
Install the TCP/IP or IPX/SPX protocol.
TCP/IP is installed on the computer,
but its IP address is not set correctly.
Set a correct IP address for the computer.
Cause
What to do
This may happen when using a
dial-up router.
Run Command Prompt from the computer on which
EpsonNet Config is installed, and then enter the following
command:
Format: >ROUTE_ADD_the IP address of the network
interface_ the IP address of the computer (the
underscore represents one space)
Example: >ROUTE ADD 192.168.192.168 22.33.44.55.
Cause
What to do
You have not set the IP address for
the network interface.
Set the IP address for the network interface using
EpsonNet Config for Windows, or the printer’s control
panel. You can check the IP address on a status sheet.
See the EpsonNet Config User’s Guide.