Epson TM-T70II TM-T70II Technical Reference Guide 1 - Page 35
Selecting the number of head energizing parts
View all Epson TM-T70II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Chapter 2 Setup Multi-tone print density Selectable from levels 1 to 13 (70% 130%) Initial setting for ANK models: level 7 (100%) Initial setting for Simplified Chinese models, Traditional Chinese models, and South Asia font models: level 11 (120%) First change the print density, and then configure the Multi-tone print density. If you set the density too high, the contrast becomes lower. Select the density level checking the overall tone balance of your image. Print speed Selectable from levels 1 to 13 (Slow Fast) Initial setting: level 13 Depending on print conditions, such as print duty, print head temperature, and data 2 transmission speed, print speed is automatically adjusted, which may cause white lines due to intermittent print (the motor sometimes stops). To avoid this, keep the print speed constant by setting it lower, or set the transmission speed higher for the serial interface. Thai character print mode (only for South Asia font models) • Thai 3 pass • Thai 1 pass (initial setting) Selecting the number of head energizing parts • One-part energizing (initial setting) • Two-part energizing Usually, the number of head energizing parts does not need to be changed. When printing at the maximum speed, select "One-part energizing." Character code table default Selectable from 43 pages including user defined page Initial setting: Page 0 (PC437: USA, Standard Europe) For the character code table, see "Character Code Tables" on page 101. User-defined page is not supported by South Asia font models. 35