Epson TM-T88III User Manual - Page 2

Printer Parts 2 cutter cover FOEEUPDTAPEERRRPOORWER 1 printer cover 4 control panel POWER ERROR PAPER OUT FEED 3 cover open button DIP Switch Tables Serial SW Function ON OFF 1-1 Data receive error Ignored Prints "?" 1-2 Receive buffer capacity 45 bytes 4K bytes 1-3 Handshaking XON/XOFF DTR/DSR 1-4 Data word length 7 bits 8 bits 1-5 Parity check Enabled Disabled 1-6 Parity selection Even Odd 1-7 Transmission speed (See table below.) 1-8 Transmission speed (bps)-bits per second 38400 4800 9600 19200 1-7 1-8 ON ON OFF ON ON OFF OFF OFF SW Function ON OFF 2-1 Handshaking Receive (BUSY condition) buffer full Offline or Receive buffer full 2-2 Do not change 2-3 Print density/ 2-4 Low power See Table A 2-5 Release Releases BUSY Releases BUSY condition of when remain- when remain- receive buffer ing receive ing receive BUSY (If receive buffer capac- buffer capac- buffer capacity ity reaches ity reaches set to 4 KB.) 138 bytes. 256 bytes. 2-6 Do not change 2-7 I/F pin 6 reset Enabled Disabled 2-8 I/F pin 25 reset Enabled Disabled Parallel SW Function ON 1-1 Auto line feed Always enabled 1-2 Receive buffer capacity 45 bytes 1-3 Select paper Disabled sensors to output paper-end signals (default value of ESC c 3) 1-4~ Undefined 1-8 OFF Always disabled 4K bytes Paper roll end sensor enabled, Paper roll nearend sensor enabled SW Function ON OFF 2-1 Handshaking Receive (BUSY condition) buffer full Offline or Receive buffer full 2-2 Do not change 2-3 Print density/Low See Table A 2-4 power 2-5 Release condition of receive buffer BUSY (If receive buffer capacity set to 4 KB.) Releases BUSY Releases BUSY when remain- when remain- ing receive ing receive buffer capac- buffer capac- ity reaches ity reaches 138 bytes. 256 bytes. 2-6~ Do not change 2-7 2-8 I/F pin 31 reset (Do not change) Table A Print density/low power - Low power consumption mode 1 (Normal) 2 (Medium) 3 (Dark) SW 2-3 ON OFF ON OFF SW 2-4 ON OFF OFF ON