Epson TM-T88V UB-P02II Users Manual - Page 3
User's Manual
View all Epson TM-T88V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
User's Manual Standards and Approvals Copyright 2008 by Seiko Epson Corporation Printed in China The following standards are also applied only to the units that are so labeled. (EMC is tested using the EPSON power suppliers and TM series printer.) Europe: CE marking North America: FCC/ICES-003 Class A Japan: VCCI Class A Oceania: AS/NZS CISPR22 Class A WARNING This is a Class A product. In a domestic environment this product may cause radio interference, in which case the user may be required to take adequate measures. The printers in which this board is installed becomes class A devices. The connection of a non-shielded printer interface cable to this board will invalidate the EMC standards of this device. You are cautioned that changes or modifications not expressly approved by Seiko Epson Corporation could void your authority to operate the equipment. CE Marking The board conforms to the following Directives and Norms: Directive 2004/108/EC EN 55022 Class A EN 55024 IEC 61000-4-2 IEC 61000-4-3 IEC 61000-4-4 IEC 61000-4-5 IEC 61000-4-6 IEC 61000-4-11 FCC Compliance Statement For American Users This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense. For Canadian Users This Class A digital apparatus complies with Canadian ICES-003. À l'intention des utilisateurs canadiens Cet appareil numérique de classe A est conforme à la norme canadienne NMB-003. Introduction This manual describes how to replace the interface board on TM series printers designed for the UB-P02II. You must check the printer settings after replacing the interface board. See the documentation that came with the printer for information about the settings. When you use the UB-P02II, note that you will not be able to use the display module (customer display) connector of the printer. About the Symbol in This Manual CAUTION: Cautions must be observed to avoid minor injury to yourself or damage to your equipment.