Epson TM-T88VI-i Users Manual - Server Direct Print - Page 15
Restriction
View all Epson TM-T88VI-i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Chapter 1 Overview Restriction ❏ If power is restored the device or the cover is open during printing, printing may not occur properly. ❏ To turn the device power off and on, be sure to allow an interval of five seconds or more between power off and on. ❏ Use a switching hub to connect the device. If no switching hubs are used, the device in online status is more likely to be judged as offline depending on the traffic condition. ❏ The drawer can be controlled when the TM printer with SDP support is online (when the roll paper is loaded and the roll paper cover is closed). When the printer is offline, it can be controlled using the ePOS- Print XML forced transmission mode. The following printers are not supported. 1 TM-i series: TM-i Firmware Ver.3.0 or earlier TM-DT series: TM-DT Software Ver.2.2 or earlier ❏ When the specified timeout time has passed after printing starts, the printing is canceled, but the data recognized by the printer before print canceling process starts is printed. ❏ Messages that contain BOM are not supported. ❏ The only supported character encoding is UTF-8. ❏ Maximum size of data that can be transmitted at once are below. TM-T88VI and TM-T88VI-iHUB 2 MB TM-i series/ TM-DT series These values depend on the TM-i firmware or TM-DT software version, and on the printing speed of the printer. For details regarding the printing speed of the printer, refer to the Technical Reference Guide for each TM printer. TM-i series TM-DT series Printing speed Firmware version TM-DT Software version 300 mm/s 200 mm/s Ver.4.0 or earlier Ver.2.5 or earlier 200 KB 133 KB Ver.4.1 - 400 KB 267 KB Ver.4.3 or later Ver.3.0 or later 2 MB 15