Epson TM-U590 TM-U590 Product Information Guide - Page 3

EPSON TM-U590 DIP Switches Serial interface Parallel interface RELEASE On to indicate that you can insert a slip. SLIP On after power on. Flashes while waiting for slip insertion and removal. Off while the printer is ejecting a slip. Buttons FORWARD Press to feed slip paper forward one line. Hold down to feed paper forward continuously. REVERSE Press to feed slip paper in reverse one line. Hold down to feed paper in reverse continuously. RELEASE Press to release slip paper. Buffer Sizes Receive User-defined 4KB or 69 bytes, selected via DIP switch 5KB Electrical Characteristics Supply voltage +24 V ± 10% (using the EPSON PS-170 or PS-180) Current consumption (approximate, at room temperature) Operating Standby Mean: Approximately 1.9 A Peak: Approximately 8 A Mean: Approximately 0.3 A Inserting Paper Control Panel 1. When the LED flashes, insert the slip, using the right edge of the paper inlet as a guide (see the illustration below). 2. Insert the slip into the inlet as far as it will go. The sensor detects the slip, and the LED goes from flashing to on. LEDs POWER On when the power is on. ERROR On if the printer is offline, except when feeding paper with the or buttons and during a self-test. Flashing if the head is too hot or there is an error. Turn the printer off, let the head cool, and turn it back on. If still flashing, contact a dealer or qualified service person. 2 - EPSON TM-U590 EPSON 2 3. After printing is done, the remove the slip. 2/02 FORWARD POEWRERRREOLSRELAIPRSEELEASE REVERSE 1 LED goes off and you can