Epson V11H179020 Start Here Card - Page 4

4 Plug in and turn on 1 Press in the tabs and remove the lens cover. 2 Connect the power cord to the projector and plug the other end into an electrical outlet. The power light turns orange. 3 If you are connecting a device other than a computer, turn on your equipment. (If you are connecting to a computer, don't turn it on yet.) 4 Press the Power button on the projector or remote control. You hear a beep, the power light flashes green, and the projector lamp comes on in about 6 seconds. The power light stays green. 5 If you are using a computer, turn it on now. 6 Start your video or presentation. If you have connected more than one video source, press the Computer or S-Video/Video button on the projector remote control to select the one you want to watch. NOTE If you connected a notebook computer and no image is being projected, you may need to set up the notebook to output signals externally. See the Troubleshooting section for instructions. Source buttons Turning off the projector 1 When you're finished using the projector, first turn off the video source. 2 Press the Power button on the projector or remote control. 3 When you see the confirmation message, press the Power button again. The power light flashes orange as the projector cools down. 4 When the power light is a steady orange, unplug the projector. Caution: Never unplug the projector when the power light is green or flashing orange.