Epson WorkForce 40 Quick Guide - Page 25

Check the table below for explanations of the printing status lights. For information about the network status lights, see the Network Installation Guide or the on-screen Epson Information Center. Light status on flashing slowly (no other lights are on) flashing fast flashing fast on on flashing slowly flashing slowly on flashing slowly flashing slowly off flashing fast flashing fast off Problem and solution The printer is turned on. The printer is in sleep mode. Press any button except the power button to wake it up. The printer cover is open. Close the printer cover. Paper is out or multiple pages have fed. Load or reload paper in the sheet feeder or press the button to eject excess sheets. Paper is jammed. Carefully remove the jammed paper. One or more cartridges have low ink. You can continue printing until a cartridge needs replacement. Check the cartridge status to determine which cartridges are affected. An ink cartridge is expended, incorrectly installed, or cannot be used with the printer. If an ink cartridge is likely to be expended or is not compatible, you must replace the cartridge to be able to print. If you just replaced a cartridge and the light is still on, the cartridge is not installed correctly. Press the button to move the cartridges to the replacement position. Open the ink cartridge cover, press down on all the installed cartridges, and close the ink cartridge cover. Then press the button to continue. Parts inside the printer are at the end of their service life. Contact Epson for help (see page 28). There is a problem with the printer. Turn it off, wait a few moments, and turn it back on again. If the error is not resolved, contact Epson for help (see page 28). Checking the Status Lights 25