Epson WorkForce 545 Start Here - Page 2
Load paper - all in one printer
View all Epson WorkForce 545 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
2 Open the cartridge cover. 3 Shake the ink cartridges gently 4 or 5 times, then unpack them. 5 Load paper You can load letter-, A4-, or legal-size paper, as well as various photo papers. For information on the papers available for your product, see the Quick Guide. For instructions on loading legal-size or photo paper, see the online User's Guide. 1 Pull out the paper cassette at the bottom of the printer. 4 Remove only the yellow tape from each cartridge. Caution: Don't remove any other seals or the cartridges may leak. 5 Insert the cartridges in the holder for each color. 6 Press each cartridge down until it clicks. 7 Close the cartridge cover. Press down until it clicks. 2 Slide the edge guides outward. 3 Position the guide shown below for the size of paper you're using. Letter LTR 4 Insert the paper with the glossy or printable side facedown. 5 Slide the edge guides against the paper, but not too tight. Make sure the paper is under the tabs on the edge guides. 8 Lower the scanner unit. 9 Press OK to prime the ink delivery system. This takes about 5 minutes. Note: Your printer ships with full cartridges and part of the ink from the first cartridges is used for priming the printer. Caution: Don't turn off the printer while it is priming or you'll waste ink. 10 When you see this menu on your product's LCD screen, do not press the OK button yet. Continue with the instructions in the following sections to load paper in your product and install software. 6 Gently insert the paper cassette. 7 Extend the output tray as shown.