Epson WorkForce Pro WF-7820 Start Here - Installation Guide - Page 2

2 Gently shake the ink cartridges, and remove them from the packaging. 3 Remove only the yellow tape from each ink cartridge. 4 Load paper See the online User's Guide for information about loading capacity, available paper types and sizes, loading envelopes, and using the rear paper feed slot or ADF. 1 Make sure the product is done charging the ink, then pull out the paper cassette. Caution: Do not remove any seals, or ink will leak. Do not touch the areas shown above. Doing so may prevent normal operation and printing. 4 Insert the cartridge in the holder for each color. Press each cartridge down until it clicks. Make sure all cartridges are pushed down into place. 2 Slide the side edge guides all the way out and set the front edge guide to the paper size you are using. 3 Insert paper with the glossy or printable side down. 5 Close the ink cartridge cover, then lower the scanner unit. Note: Make sure the paper is under the arrow mark for your paper type and loaded against the front edge of the cassette. 6 The product starts charging the ink. Ink charging takes approximately 5 minutes. When you see a completion message on the product's LCD screen, charging is complete. Caution: Don't turn off the printer or raise the scanner unit while the printer is charging or you'll waste ink. Note: As part of setup, your product's serial number will be sent to a secure Epson server so that you can be eligible to participate in programs we may offer from time to time, including the Epson ink replenishment program. You will have a separate opportunity to consent to participating in such programs. 4 Slide the edge guides against the paper, but not too tightly. 5 Keep the cassette flat as you insert it all the way. 6 Select the paper settings on the product's control panel.