Epson WorkForce Pro WP-4540 Start Here - Page 2

3 Shake each cartridge as shown for about 5 seconds. 2 Slide the edge guides outward. 4 Install each cartridge in the correct slot for its color. Push each cartridge in until it clicks. 5 Close the front cover. The printer starts priming the ink. This takes about 12 minutes. When the green power light stops flashing, priming is complete.  N ote: The included cartridges prime the printer and print about 1000 black pages/900 color pages. Actual page count will vary.  C aution: Don't turn off the printer or open the cover while it is priming or you'll waste ink. 6 When you see this menu on your product's LCD screen, do not press any buttons yet. Continue with the instructions in the following sections to load paper into your product and install software. N ote: If loading legal-size paper, extend the cassette as shown. 3 Insert the paper with the printable side facedown. N ote: Make sure the paper is loaded against the edge guide and not sticking out from the end of the cassette. 4 Slide the edge guides against the paper, but not too tight. Make sure the paper is under the tabs on the edge guides. 5 Load paper in the cassettes You can load letter-, A4-, or legal-size plain paper in the cassettes. For instructions on loading envelopes and special paper in the rear MP tray, see the online User's Guide. 1 Pull out the desired paper cassette. 5 Gently insert the paper cassette at the bottom of the printer. N ote: The paper may slide forward slightly as you insert the cassette. This is normal. 6 Extend the output tray and raise the paper stopper as shown. (Do not raise the paper stopper for legal-size paper.)