Epson WorkForce ST-3000 Start Here - Installation Guide - Page 1
Epson WorkForce ST-3000 Manual
View all Epson WorkForce ST-3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
ST-3000/ST-4000 Start Here IMPORTANT: Before using this product, make sure you read these instructions and the safety instructions in the online User's Guide. Important Safety Instructions: When using telephone equipment, you should always follow basic safety precautions to reduce the risk of fire, electric shock, and personal injury, including the following: • Do not use the Epson® product near water. • Always keep this guide handy. • Avoid using a telephone during an electrical storm. There may be a remote risk of electric shock from lightning. • Do not use a telephone to report a gas leak in the vicinity of the leak. Caution: To reduce the risk of fire, use only a No. 26 AWG or larger telecommunication line cord. The illustrations show the ST-4000, but the steps are the same for all models, unless otherwise specified. 1 Unpack 2 Lift up the scanner unit. Remove all protective materials from inside the product. Caution: Do not touch the flat white cable or the ink tubes and their translucent cover. 2 Fill ink tanks Note: This product requires careful handling of ink. If ink spills, wipe it off immediately with a damp towel to avoid permanent stains. If ink gets on your clothes or belongings, it may not come off. Caution: Keep the ink bottles out of the reach of children and do not drink the ink. 1 Open the ink tank cover, then open the cap for the ink tank you are going to fill. Note: Do not open the ink bottles until you are ready to fill the ink tanks. The ink bottles are vacuum packed to maintain reliability. 1 Remove all protective materials from the product. 2 Unpack one of the ink bottles. Hold the ink bottle upright and slowly turn the bottle cap to remove it. Caution: Do not shake or squeeze the ink bottles. Do not touch the top of the ink bottle after its cap is removed. 3 Position the top of the ink bottle along the slot in front of the filling port, then slowly stand the bottle up to insert it. Note: Refer to the color-coded sticker to identify the color of each tank. Do not force the bottles into position; they are keyed for each color.