Epson WorkForce WF-2830 Start Here - Installation Guide - Page 2

3 Install ink cartridges Caution: Keep the ink cartridges out the reach of children and do not drink the ink. Note: The included initial cartridges are designed for reliable printer setup and cannot be used as replacement cartridges or resold. After setup, the remaining ink is available for printing. 1 Lift up the scanner unit until it locks into place. 2 Gently shake the Black (BK) ink cartridge. Note: Do not shake the other ink cartridges. 3 Unpack the ink cartridges. 4 Remove only the yellow tape from each ink cartridge. 6 Lift the scanner unit up slightly and lower it. When the scanner unit catches, lift it up again and lower it completely. 7 Follow the on-screen instructions to start charging the ink. Ink charging takes approximately 6 minutes. When you see a completion message on the product's LCD screen, charging is complete. Caution: Don't turn off the printer or raise the scanner unit while the printer is charging or you'll waste ink. Note: As part of setup, your product's serial number will be sent to a secure Epson server so that you can be eligible to participate in programs we may offer from time to time, including the Epson ink replenishment program. You will have a separate opportunity to consent to participating in such programs. 8 Follow the on-screen instructions to adjust the print quality of your product. Note: • You need to load paper before you can adjust the print quality. See "Load paper" below for details. • Select Adjust Later if you want to adjust the print quality later. For more information, see the online User's Guide. 4 Load paper See the online User's Guide for information about loading capacity, available paper types and sizes, and loading envelopes. 1 Make sure the product is done charging the ink, and then pull out the rear paper support. Caution: Do not touch the circled area on the cartridge. Doing so may prevent normal operation and printing. 5 Insert the cartridge in the holder for each color. Press each cartridge down until it clicks. Make sure all cartridges are pushed down into place. 2 Slide the edge guides all the way out.