Epson WorkForce WF-2830 Quick Guide and Warranty - Page 3

■ When using TCP/IP, make sure your network's DHCP option is enabled (your router manufacturer will be able to assist you with this setting). ■ Print a network status sheet from the product's control panel. Load a few sheets of plain paper in your product. Press if necessary, and then do one of the following: ■ WF-2830: Select Settings > Network Settings > Print Status Sheet. Then press the start button. ■ WF-2850: Select Settings > General Settings > Network Settings > Network Status > Print Status Sheet. Then press the start button. ■ Remove and reinstall your product software. Printing a Connection Check Report You can print a network connection report and check for any error codes and messages to solve problems you may encounter with network connections. 1. Load a few sheets of plain paper in your product. 2. Press if necessary, and then do one of the following: ■ WF-2830: Select Settings > Network Settings > Connection Check, and press the start button. ■ WF-2850: Select Settings > General Settings > Network Settings > Connection Check > Print Check Report. 3. The connection report prints. Check for any error codes and follow the solutions on the report. Message or solution Error code Below are a few common error codes and solutions. If you do not see your error code listed here, see the online User's Guide. Error code E1: Make sure your router, access point, and/or hub are turned on, and the network cable is securely connected to your device and to your product. Printing a Connection Check Report 3