Epson WorkForce WF-2860 Start Here - Installation Guide - Page 2
Load paper - all in one printer
View all Epson WorkForce WF-2860 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
4 Remove only the yellow tape from each ink cartridge. 2 Squeeze the tab on the right edge guide and slide the side edge guides all the way out. Caution: Do not remove any other labels or seals, or ink will leak. Do not touch the green chip on the cartridge. 5 Insert the cartridge in the holder for each color. Press each cartridge down until it clicks. Make sure all cartridges are pushed down into place. 3 Insert paper with the glossy or printable side down. 6 Lower the scanner unit, then select Installed to start charging the ink delivery system. 4 Slide the edge guides against the paper, but not too tightly. 7 The printer starts charging the ink. Ink charging takes approximately 5 minutes. When you see a completion message on the printer's LCD screen, charging is complete. Caution: Don't turn off the printer or raise the scanner unit while the printer is charging or you'll waste ink. Note: • The printer is designed for use with Epson® cartridges only, not third-party cartridges or ink. • The cartridges included with the printer are designed for printer setup and not for resale. After some ink is used for charging, the rest is available for printing. 4 Load paper 1 Make sure the product is done charging the ink, and then pull out the paper cassette. 5 Keep the cassette flat as you insert it all the way. 6 Pull out the output tray. 7 Follow the instructions on the LCD screen to adjust the print quality and to select your paper settings. For instructions on loading envelopes or legal-size paper, see the online User's Guide.