Epson WorkForce WF-7520 Start Here - Page 2
Load paper - wide format all in one
View all Epson WorkForce WF-7520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
2 Open the cartridge cover. 3 Shake the ink cartridges gently 4 or 5 times, then unpack them. 5 Load paper You can load 3.5 5 inch (89 127 mm) to 13 19 inch (330 453 mm) paper. For instructions on loading envelopes, legal-size paper or larger paper, see the online User's Guide. 1 Pull out one of the paper cassettes at the bottom of the printer. 4 Remove only the yellow tape from each cartridge. 2 Slide the edge guides outward, and position the guide shown below for the size of paper you're using. Caution: Don't remove any other seals or the cartridges may leak. 5 Insert the cartridges in the holder for each color. Note: To load wide-format paper, press the tray release button and pull the paper tray as shown until it clicks into place. 6 Press each cartridge down until it clicks. 7 Close the cartridge cover. Press down until it clicks. 3 Insert the paper with the glossy or printable side facedown. 4 Slide the edge guides against the paper, but not too tight. Make sure the paper is under the tabs on the edge guides. 8 Lower the scanner unit. 9 Press OK to prime the ink delivery system. This takes about 5 minutes. Note: Your printer ships with full cartridges and part of the ink from the first cartridges is used for priming the printer. Caution: Don't turn off the printer while it is priming or you'll waste ink. 10 When you see this menu on your product's LCD screen, do not press any buttons yet. Continue following the instructions in the following sections to load paper in your product and install software. 5 Replace the cover and gently insert the paper cassette. 6 Extend the output tray as shown.