Epson WorkForce WF-7720 Start Here - Installation Guide - Page 2
Load paper - printer
View all Epson WorkForce WF-7720 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
4 Remove only the yellow tape from each ink cartridge. 2 Slide the side edge guides all the way out and set the front edge guide to the paper size you are using. Caution: Do not remove any other labels or seals, or ink will leak. Do not touch the green chip on the cartridge. 5 Insert the cartridge in the holder for each color. Press each cartridge down until it clicks. Make sure all cartridges are pushed down into place. 3 Insert paper with the glossy or printable side down. 6 Close the ink cartridge cover and lower the scanner unit. Note: Make sure the paper is loaded against the front edge guide and not sticking out from the end of the cassette. 4 Slide the edge guides against the paper, but not too tightly. 7 The printer starts charging the ink. Ink charging takes approximately 6 minutes. When you see a completion message on the printer's LCD screen, charging is complete. Caution: Don't turn off the printer or raise the scanner unit while the printer is charging or you'll waste ink. Note: • The printer is designed for use with Epson® cartridges only, not third-party cartridges or ink. • The cartridges included with the printer are designed for printer setup and not for resale. After some ink is used for charging, the rest is available for printing. 4 Load paper 1 Make sure the product is done charging the ink, and then pull out the paper cassette and remove the paper cassette cover. 5 Reattach the paper cassette cover and keep the cassette flat as you insert it all the way. 6 Pull out the output tray extension. 7 Select the paper settings on the product's control panel. For instructions on loading envelopes, legal-size paper, or using the rear paper feed slot, see the online User's Guide.