Epson WorkForce WF-M1030 Notices - Page 2
Wireless Network Safety, Ink Cartridge Safety
View all Epson WorkForce WF-M1030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
■ Do not use aerosol products that contain flammable gases inside or around the product. Doing so may cause fire. ■ Do not touch the flat white cable inside the product. ■ Do not spill liquid on the product. Do not use the product near water. Do not use with wet hands. ■ Unplug the product and refer servicing to qualified service personnel under the following conditions: if the power cord or plug is damaged; if liquid has entered the product; if the product has been dropped or the case damaged; if the product does not operate normally or exhibits a distinct change in performance. ■ Never disassemble, modify, or attempt to repair any part of the product by yourself, except as specifically explained in the documentation. Do not adjust controls that are not covered by the operating instructions. ■ When storing or transporting the product, do not tilt it, stand it on its side, or turn it upside down; otherwise ink may leak from the cartridge. Wireless Network Safety To avoid adversely affecting the operation of the following equipment and causing an accident, do not use the product: near medical equipment in a medical facility; within 9 inches (22 cm) of a cardiac pacemaker; near automatically controlled devices, such as automatic doors or fire alarms. Ink Cartridge Safety ■ Keep ink cartridges out of the reach of children. ■ Be careful when you handle used ink cartridges; there may be ink remaining around the ink supply port. If ink gets on your skin, wash it off with soap and water. If ink gets into your eyes, flush them immediately with water. If ink gets in your mouth, spit it out and see a doctor right away. ■ Do not put your hand inside the product or touch the cartridge during printing. ■ Do not try to move the print head by hand, or you may damage the product. ■ Before transporting the product, make sure the print head is in the home (far right) position and the ink cartridge is in place. ■ Install a new ink cartridge immediately after removing a used one. Leaving the cartridge uninstalled can dry out the print head and may prevent the product from printing. ■ Do not shake the ink cartridge too vigorously or after opening their packages; this can cause them to leak. ■ Be careful not to break the hooks on the side of the ink cartridge when you remove it from the package. ■ Do not touch the green IC chip or the small window on the side of the cartridge. This may prevent normal operation. 2 Important Safety Instructions