Esoteric N-01XD Owners ManualEN FR SP - Page 19

English ETHERNET port LED setting Remote control operation setting LanLED>*** Use to set the ETHERNET port LED. When set to OFF, the ETHERNET port LED will not light, reducing the impact on audio quality. oo By default, the setting is OFF. oo Even when set to OFF, the LED will blink immediately after a LAN cable is connected and while the unit is initializing after being turned on (while "WAIT..." displayed). OFF The ETHERNET port LED stays unlit. ON Lighting and blinking of the ETHERNET port LED are enabled. Network input circuit power supply setting NETin>*** Use to turn the network input circuit power supply on and off. oo By default, the setting is ON. REMOTE>*** Use this to set signal reception from ESOTERIC remote controls included with the P-05X and other products. By default, the setting is OFF. oo Regardless of this setting, remote control DIMMER buttons will function. oo Set this to OFF when you are using an ESOTERIC amplifier. If set to ON, the amplifier will be operated at the same time. OFF This disables control of this product using the buttons on the remote control. ON This enables control of this product using the buttons for amplifier control on remote controls. The following table shows the correspondence between remote control and unit buttons. Remote control SETUP button INPUT button VOLUME (+/−) buttons N-01XD MENU button INPUT button Setting adjustment (l/;) buttons ON This turns the network input circuit power supply on and plays audio files from the network. OFF This turns the network input circuit power supply off, stopping operation of the network input circuit. NET will not be shown as an input source option (page 12). Showing firmware versions F/W ver. Press the ; setting adjustment button when "F/W ver." is shown to check the versions of other firmware. I/F **** I/F firmware NET **** Network firmware M ***** MQA/USB firmware DIG **** Digital FPGA firmware DAC L**R** DAC FPGA firmware 19