Eufy RoboVac 15C Max RoboVac 11S11S Max15C Max_EN_Manual - Page 9

BoostIQ™ Feature When the BoostIQ™ feature is enabled, RoboVac will automatically increase the suction power if it detects stronger power is needed to ensure the best clean. BoostIQ™ is ideal for cleaning thicker carpets and hard-tosweep messes, which will reduce the total cleaning time, but increase the noise level. If the vacuuming noise caused by BoostIQ™ disturbs you, you can disable this feature. This feature only works in Auto and Quick cleaning modes. In Auto or Quick cleaning mode, press on the remote control repeatedly to adjust the suction power level. • The corresponding icon is displayed on the remote control. Icon Standard BoostlQ Max Suction Power Level Standard power Automatically switches between Standard and Enhanced power (default) Maximum power • When RoboVac starts cleaning in Auto or Quick cleaning mode the next time, it will clean according to the suction power level you previously selected. B. Spot cleaning RoboVac intensively cleans a specific area in a spiral pattern, useful if there is a concentrated area of dust or debris. In Spot mode, RoboVac will stop cleaning after 2 minutes. Press on the remote control to start cleaning in Spot mode. C. Edge cleaning RoboVac reduces its speed when it detects a wall and then follows the wall to ensure the edge is cleaned thoroughly. In Edge mode, RoboVac will clean for 20 minutes and return to the Charging Base. Press on the remote control to start cleaning in Edge mode. 14 EN D. Quick cleaning RoboVac will automatically stop cleaning after 30 minutes and return to the Charging Base in this mode. If any small room or area needs to be cleaned, it is recommended to select this mode to save time and power. Press on the remote control to start quick cleaning mode. E. Manual cleaning You can direct RoboVac to clean a particular area by using the directional buttons on the remote control. Turn left Move backward Move forward Turn right Set Time and Scheduled Cleaning Set Time • Make sure the time is set correctly to your local time before setting a scheduled cleaning. • For 15C Max (T2128) without the remote controller, you can directly set time and scheduled cleaning via eufy Clean app. 1 Make sure the main power switch on the bottom of RoboVac is turned on. 2 Press on the remote control. The time will blink on the display. 3 Press to set the "hour" and "minute". 4 Press or to save the setting. RoboVac will BEEP ONCE to indicate the time has been set. ON 1 4 EN 15