Eureka Maxima 4704FRD Owner's Guide - Page 5

How to Use Accessories

Page 5 highlights

ENGLISH How to Use Accessories ! Handle must be in upright position to ensure that brush roll is lifted off the floor. Replace hose end into opening on vacuum base after using accessories. Combination Crevice Tool and Extension Wand Use for baseboards, corners and between cushions. 1) Loosen hose end from vacuum base. 2) Grasp crevice tool near ridges and pull apart. 3) Turn ridge end to center. 4) Push crevice tool into wand and place on end of hose. Dusting Brush Use for furniture, drapes, blinds, bookshelves, lampshades and vents. 1) Remove hose from hose retainer on back of vacuum. 2) Place dusting brush on end of hose, wand or crevice tool. Power Paw® (with some models or available for purchase - part number 62550B) Stair Hose (hose available for purchase - part number 62293-10) Use for furniture and stairs. Make sure vacuum is below you, pushed against the bottom step. 1) If model has additional stair hose, attach to end of hose. 2) Attach Power Paw to the end of wand or hose. Make sure you turn off vacuum before removing debris from Power Paw. Eureka Customer Service HELPLINE 1-800-282-2886 www.eureka.com 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

3
3
Eureka Customer Service HELPLINE 1-800-282-2886
www.eureka.com
ENGLISH
Dusting Brush
Use for furniture, drapes, blinds,
bookshelves, lampshades and vents.
1) Remove hose from hose retainer
on back of vacuum.
2) Place dusting brush on end of hose,
wand or crevice tool.
Power Paw
®
(with some models or available for purchase – part number 62550B)
Stair Hose
(hose available for purchase – part number 62293-10)
Use for furniture and stairs.
Make sure vacuum is below you,
pushed against the bottom step.
1) If model has additional stair hose,
attach to end of hose.
2) Attach Power Paw to the end of
wand or hose.
Make sure you turn off vacuum
before removing debris from
Power Paw.
Combination Crevice Tool and Extension Wand
Use for baseboards, corners and
between cushions.
1) Loosen hose end from vacuum base.
2) Grasp crevice tool near ridges and
pull apart.
3) Turn ridge end to center.
4) Push crevice tool into wand and
place on end of hose.
Handle must be in upright position to ensure that brush roll is lifted off the floor.
Replace hose end into opening on vacuum base after using accessories.
!
How to Use Accessories