Fantec SB-200BT Manual - Page 11

Standby / Off: There are 2 ways to switch the device off: press and hold the volume control knob more than 3 seconds to shift into standby mode, or switch off the soundbar completely with the On/Off switch (10) on the rear panel. Warnings: Use Instructions Do not modify the hardware or software of the device; this will void your warranty. Use the soundbar in ambient temperatures between +5°C and +35°C. Power Supply The soundbar works with 12VDC power supply. Connect the supplied AC power adaptor to a power outlet to power the soundbar. To avoid the risk of electric shock disconnect the power adaptor from mains power supply before cleaning. Do not connect the power adaptor in damp or dusty conditions. Always use the original power adaptor for the soundbar. Interference Nearly all electric devices can cause interference if they are not specially shielded. Under certain circumstances your soundbar can be affected. Repairs Turn to an authorized service center if you experience problems with the soundbar. Do not try to repair the soundbar yourself; this can damage the soundbar and cause personal injuries. Disposal At the end of its useful life dispose of the soundbar in environmentally correct manner. Some countries have regulations for the disposal of waste electric and electronic appliances. Please respect these regulations Miscellaneous Protect the soundbar from water and other liquids. If accidentally water is splashed on the soundbar, please wipe it off immediately with a dry cloth. Electronic devices are delicate. Avoid vibrations and impacts, especially during operation. Do not press buttons too hard and avoid the vicinity of strong magnetic fields. Protect the soundbar from water and other liquids. Do not try to repair the soundbar and do not modify its design. You will forfeit your warranty claims and the soundbar can be damaged. The device may show malfunctions during electrostatic discharge and in strong magnetic fields. In this case disconnect from mains power supply and reconnect after a few minutes. The device should be reset and again fully functional. Homepage: http://www.fantec.de Forum: http://www.fantec-forum.de eMail: [email protected]