Fellowes 425Ci Manual 2 - Page 2

See safety instructions below Card/CD entry CD flap Shredder head Paper entry ENGLISH Models C-420/C-420C Disconnect power switch Control panel Paper jam Bin full Door open (red) (red) (red) Turbo Jam Release Button Door Casters Pocket for manual and oil Auto-On (I) Off (O) Reverse (R) Standby (green) Bin CAPABILITIES Will shred: Paper, credit cards, CD/DVDs, staples and small paper clips Will not shred: Adhesive labels, transparencies, newspaper, cardboard, large paper clips, laminates or plastic other than noted above Paper shred size: Strip-Cut 7/32" (5.8mm) Confetti-Cut 5/32" x 1-1/8" (3.9 x 30mm) Maximum: Sheets per pass (Strip-Cut 36-38* Sheets per day (Strip-Cut 20,000 Sheets per pass (Confetti-Cut 22-24* Sheets per day (Confetti-Cut 10,000 Cards/CDs per pass 1 Cards per day 400 CDs per day 10 Paper width 12" (300mm) *20lbs., 8.5"x11" paper at 120v, 60 Hz, 12 Amps; heavier paper, humidity or other than rated voltage may reduce capacity. IMPORTANT SAFETY INSTRUCTIONS - Read Before Using! away from paper entry. Always set to Off (O) or unplug when not in use. • Keep foreign objects - gloves, jewelry, clothing, hair, etc.- away from shredder openings. If object enters top opening, switch to Reverse (R) to back out object. • Never use aerosol, petroleum-based or other flammable products on or near shredder. Do not use canned air on shredder. • Do not use if damaged or defective. Do not open shredder head. Do not place near or over heat or water source. • 36-38 (C-420)/22-24 (C-420C) sheets per pass to avoid jams. • Avoid touching exposed blades under Confetti-Cut shredder head. • Use only designated entry for cards/CDs. Keep finger away from CD hole. 2 • The grounded socket-outlet shall be installed near the equipment and shall be easily accessible. OPERATION Shredder comes ready to use. Disconnect power switch must be in ON position to operate shredder. Insert waste bag (Fellowes #3605801) for easy disposal. PAPER CARD/CD Set to Off (O) and plug in Press Auto-On (I) Feed into paper entry and release Press Auto-On (I) Hold card/CD at edge Feed into card/CD entry and release Set to Off (O) TROUBLESHOOTING Paper jam: Set to Off (O) and empty bin. Replace bin, close door, and follow any or all of the below procedures. Strip Cut: Press and hold Turbo Jam Release Button Press and hold Reverse (R) for 1 second Confetti-Cut: Press and hold Turbo Jam Release Button Press and hold Reverse (R) for 1 second Open CD flap Remove all uncut paper from entry Pull several sheets of uncut paper from entry Press and hold Turbo Jam Release Button. Repeat procedure if still in jam mode. Press and hold Turbo Jam Release Button Indicator lights: Make sure door is tightly closed Paper Jam Remove and empty bin MAINTENANCE Confetti-Cut and Strip-Cut: Follow oiling procedure below and repeat twice. Run regularly in reverse for one minute Confetti-Cut only: Lubricate when bin is full, or immediately, if: • Capacity decreases • Motor sounds different, or shredder stops running Press and hold *Apply oil across entry Press Auto-On (I) Shred one sheet *Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes #35250 Press and hold Reverse (R) 2-3 seconds WARRANTY Our promise to you is quite simple. Fellowes shredders are built stronger, repair or replacement, at Fellowes' option and expense, of the defective part. This engineered to run longer, resist jams and power through large jobs. The Fellowes warranty does not apply in cases of abuse, mishandling, or unauthorized repair. worry free warranty described below covers the performance of the product, ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR provides for prompt service and support, plus a lifetime cutter warranty. A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any to be free of defects in material and workmanship and provides service and consequential or incidental damages attributable to this product. This warranty support for 3 years from the date of purchase by the original consumer. Fellowes gives you specific legal rights. The duration, terms, and conditions of this warranty warrants the cutting blades of the machine to be free from defects in material are valid worldwide, except where different limitations, restrictions, or conditions and workmanship for the lifetime of the shredder. If any part is found to be may be required by local law. For more details or to obtain service under this defective during the warranty period, your sole and exclusive remedy will be warranty, please contact us or your dealer. 3