Fellowes 450Ms Manual - Page 2

To Test SafeSense, Technology, IMPORTANT SAFETY INSTRUCTIONS - Read Before Using, CAPABILITIES - fellows shredder

Page 2 highlights

Shredder head Sheet capacity icon Paper entry Indicator lights Ready (green) Overheated Window Pull-out bin Control switch Breakthrough Safety Technology! SafeSense® stops shredding when hands are too close to the opening. - To Test SafeSense® Technology Press Auto-On (I) Touch test area ENGLISH Model MS-450Cs SafeSense® Technology Card/CD entry See safety instructions below SafeSense® (yellow) SafeSense® override switch Active Not Active Disconnect power switch Auto (I) Off (O) Sensor lights up CAPABILITIES Will shred: Paper, credit cards, CD/DVDs and staples Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard, paper clips,* laminates or plastic other than noted above Paper shred size: Confetti-Cut 5/64" x 5/16" (2 x 8mm) Card/CD shred size: Strip-Cut 5/16" (8mm) *Paper clip shredding is not recommended for this shredder. Maximum: Sheets per pass (Confetti-Cut 7* Cards/CDs per pass 1 Paper width 8.75"/220mm Card/CD width 5"/125mm Continuous operation 8-10 minutes *20lb., 8.5"x11" (75g) paper at 120v, 60 Hz, MS-450Cs-4.5Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates: 25-50 paper passes; 25 cards; 5 CDs. Fellowes SafeSense® shredders are designed to be operated in home and office environments ranging between 50 - 80 degrees Fahrenheit (10 - 26 degrees Celsius) and 40 - 80% relative humidity. IMPORTANT SAFETY INSTRUCTIONS - Read Before Using! • Keep away from children and pets. Keep hands away from paper entry. Always unplug when not in use. • Keep foreign objects - gloves, jewelry, clothing, hair, etc. - away from shredder openings. If object enters top opening, switch to Reverse ( ) to back out object. • Never use aerosol, petroleum based or other flammable products on or near shredder. Do not use canned air on shredder. • Do not use if damaged or defective. Do not open shredder head. Do not place near or over heat or water source. • 7 sheets per pass to avoid jams. • Avoid touching exposed blades under Confetti-Cut shredder head. • Use only designated entry for cards/CDs. Keep finger away from CD hole. 2 • The grounded socket-outlet shall be installed near the equipment and shall be easily accessible. • Paper and Card/CD cannot be shredded at same time. OPERATION Disconnect power switch must be in ON (I) position to operate shredder. Insert waste bag (Fellowes #36052) for easy disposal. PAPER Continuous operation: 8-10-minute maximum NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 8-10-minutes will trigger a cool down period to resume operation. Set to Off (O) CARD/CD and plug in Press Auto-On (I) Press Auto-On (I) Feed into paper entry and release Set to Off (O) and unplug Hold card/CD at edge Feed into card/CD entry and release TROUBLESHOOTING Paper jam: Set to Off and empty bin. Replace bin and follow any or all of the below procedures. Shredder doesn't start: Yellow - SafeSense® active Yellow flashing - SafeSense® not active Press and hold Reverse ( ) Alternate slowly back and forth Set to Off (O) and unplug Gently pull uncut paper from paper entry. Plug in. Press and hold Reverse ( ) Make sure bin is pushed in Wait for motor to cool down ATTENTION: If the SafeSense® light remains on, you must engage the Override Switch in order to perform steps above. Once the jam is cleared, reset the SafeSense® feature. (See SafeSense® instructions below.) SafeSense® paper jam: If the SafeSense® feature activates (SafeSense® light remains on) to cause the user to think the shredder has jammed when it has not, use the Override Switch to deactivate the SafeSense® feature and clear the paper. Warning - when switch is in override position, the SafeSense® light will flash and the SafeSense® feature will NOT function. Once the paper is cleared, reset the SafeSense® feature. Sensor light illuminated-paper jammed SafeSense® override switch MAINTENANCE Active Not active Run regularly in reverse for one minute Follow oiling procedure below and repeat twice. Oil when bin is full, or immediately, if: • Capacity decreases • Motor sounds different, or Shredder stops running *Apply oil across entry Press forward Shred one sheet Press and hold Reverse ( ) 2-3 seconds *Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250/3505006 WARRANTY LIMITED WARRANTY Fellowes, Inc. ("Fellowes") warrants the cutting blades of the machine to be free from defects in material and workmanship for 5 years from the date of purchase by the original consumer. Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1 year from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer. 3

  • 1
  • 2

2
See safety instructions below
GLISH
E
EN
EN
EN
ENG
ENG
ENG
ENGL
ENGL
ENGL
ENGLI
ENGLIS
ENGLIS
ENGLIS
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
Model MS-450Cs
Model MS-450C
— To Test SafeSense
®
Technology
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
CAPABILITIES
Breakthrough Safety Technology! SafeSense
®
stops shredding when hands are too close to the opening.
• Keep away from children and pets. Keep hands away from
paper entry. Always unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc.
– away from shredder openings. If object enters top opening,
switch to Reverse (
) to back out object.
• Never use aerosol, petroleum based or other flammable products on or
near shredder. Do not use canned air on shredder.
• Do not use if damaged or defective. Do not open shredder head. Do not
place near or over heat or water source.
• 7 sheets per pass to avoid jams.
• Avoid touching exposed blades under Confetti-Cut shredder head.
• Use only designated entry for cards/CDs. Keep finger away from CD hole.
• The grounded socket-outlet shall be installed near the equipment and shall be
easily accessible.
• Paper and Card/CD cannot be shredded at same time.
Will shred:
Paper, credit cards, CD/DVDs and staples
Will not shred:
Continuous forms, adhesive labels, transparencies, newspaper,
cardboard, paper clips,* laminates or plastic other than noted above
Paper shred size:
Confetti-Cut
...............................................................
5/64” x 5/16” (2 x 8mm)
Card/CD shred size:
Strip-Cut
........................................................................................
5/16” (8mm)
*Paper clip shredding is not recommended for this shredder.
Maximum:
Sheets per pass (Confetti-Cut)
.........................................................................
7*
Cards/CDs per pass
..........................................................................................
1
Paper width
..................................................................................
8.75”/220mm
Card/CD width
..................................................................................
5”/125mm
Continuous operation
......................................................................
8-10 minutes
*20lb., 8.5”x11” (75g) paper at 120v, 60 Hz, MS-450Cs–4.5Amps; heavier paper, humidity
or other than rated voltage may reduce capacity. Recommended daily usage rates: 25-50
paper passes; 25 cards; 5 CDs.
Fellowes SafeSense
®
shredders are designed to be operated in home and office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
Paper entry
Window
Pull-out bin
Shredder head
Sheet capacity icon
Ready (green)
Overheated
Indicator lights
Control switch
Card/CD entry
SafeSense
®
Technology
SafeSense
®
(yellow)
Press Auto-On (I)
Touch test area
Sensor lights up
SafeSense
®
override switch
Active
Not Active
Auto (I)
Off (O)
Disconnect power switch
Press and hold Reverse (
)
2-3 seconds
Press and hold
Reverse (
)
Set to Off (O)
and unplug
Press Auto-On (I)
Set to Off (O)
and unplug
Feed into paper entry
and release
Set to Off (O)
and plug in
LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free from
defects in material and workmanship for 5 years from the date of purchase by the original consumer.
Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1
year from the date of purchase by the original consumer. If any part is found to be defective during the
warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and
expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED
WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE,
IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE.
In no event shall Fellowes be liable for any consequential or incidental damages attributable to
this product.
This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid
worldwide, except where different limitations, restrictions, or conditions may be required by local law.
For more details or to obtain service under this warranty, please contact us or your dealer.
Continuous operation:
8-10-minute maximum
NOTE:
Shredder runs briefly after
each pass to clear entry.
Continuous operation beyond
8-10-minutes will trigger a cool
down period to resume operation.
Gently pull uncut paper
from paper entry. Plug in.
Run regularly in reverse for
one minute
Oil when bin is full, or
immediately, if:
• Capacity decreases
• Motor sounds different, or
Shredder stops running
OPERATION
TROUBLESHOOTING
MAINTENANCE
3
Shredder doesn’t start:
Follow oiling procedure below and repeat twice.
WARRANTY
Alternate slowly back and forth
Press forward
*Apply oil
across entry
Press Auto-On (I)
Yellow - SafeSense
®
active
Yellow flashing - SafeSense
®
not active
Make sure bin is pushed in
Wait for motor to cool down
Shred one sheet
Paper jam:
Set to Off and empty bin. Replace bin and follow any or all of the below procedures.
PAPER
CARD/CD
Hold card/CD at edge
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250/3505006
Feed into card/CD entry
and release
ATTENTION:
If the SafeSense
®
light remains on, you must engage the
Override Switch
in order to perform steps above. Once the jam is cleared, reset the
SafeSense
®
feature. (See SafeSense
®
instructions below.)
SafeSense
®
override switch
Active
Not active
Sensor light illuminated–paper
jammed
SafeSense
®
paper jam:
If the SafeSense
®
feature activates (SafeSense
®
light remains on) to cause the user
to think the shredder has jammed when it has not, use the
Override Switch
to deactivate the SafeSense
®
feature and clear the paper.
Warning
– when switch is in override position, the SafeSense
®
light will flash and
the SafeSense
®
feature will NOT function. Once the paper is cleared, reset the SafeSense
®
feature.
Press and hold
Reverse (
)
Disconnect power switch must be in ON (I) position to operate shredder. Insert waste bag (Fellowes #36052) for easy disposal.