Fellowes 455Ms Manual - Page 3

BASIC SHREDDING OPERATION PAPER OR CD/CARD Continuous operation: Up to 10-minutes maximum NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 10-minutes will trigger 20-minute cool down period. 1 Plug in and turn ON (I) 2 9 Feed paper/card straight into paper entry and release ADvANCED PRODUCT FEATURES SafeSense® Technology Stops shredding immediately when hands touch the paper opening. 3 or 9 Hold CD at edge, feed into center of entry and release 4 When finished shredding set to OFF (O) SilentShred™ Technology SilentShred™ noise quality shreds without noisy disruptions. SAFESENSE® TECHNOLOGY Stops shredding immediately when hands touch the paper opening. SET-UP AND TESTING 1 2 9 3 9 Turn the shredder ON (I) to activate SafeSense® Touch test area and look for the SafeSense® indicator to illuminate SafeSense® is active and working properly For more information about all of Fellowes Advanced Product Features go to www.fellowes.com PRODUCT MAINTENANCE OILING SHREDDER All micro-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding, and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin. FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE 1 2 CLEANING AUTO-START INFRARED SENSORS Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run even if there is no paper present. (Note: two paper detection sensors are located in the center of the paper entry). TO CLEAN THE SENSORS 1 2 3 4 9 *Apply oil across entry Press and hold forward ( ) 2-3 seconds Turn OFF (O) and unplug shredder 9 Locate Auto-start infared sensor *Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250 Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers. Dip cotton swab in rubbing alcohol 9 Using cotton swab, wipe away any contamination from the paper sensors TROUBLESHOOTING 15 Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder. SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate and the shredder will stop shredding. 3