Fellowes 63Cb Manual - Page 3

ADVANCED PRODUCT FEATURES Jam BlockerTM Blocks jams before they start JAM BLOCKERTM Blocks jams before they start 1 2 Patented SafeSense® Technology Stops shredding immediately when hands touch the paper opening Energy Saving System Optimal energy efficiency 100% of the time - in use and out of use. If Remove Paper icon illuminates during the shredding process (due to paper misfeed or wrinkle) follow the procedures below. 1 2 3 If Remove Paper icon ( ) is illuminated, there is too much paper for the shredder to power through Reduce paper quantity to an acceptable amount and refeed into paper entry Shredder pauses for 3 seconds Set to Reverse ( ) Set to Auto On ( ) and and remove paper refeed into paper entry SAFESENSE® TECHNOLOGY Stops shredding immediately when hands touch the paper opening. SET-UP AND TESTING 1 2 3 4 Set to Auto On ( ) Touch test area and look for the SafeSense® indicator to illuminate SafeSense® is active and working properly If hand is held on SafeSense® area more than 3 seconds shredder will shut off For more information about all of Fellowes Advanced Product Features go to www.fellowes.com ENERGY SAVING SYSTEM Optimal energy efficiency 100% of the time - in use and out of use. • Saves energy in four ways: energy-efficient electronics, jam prevention, standby mode and sleep mode. • Sleep Mode shuts down shredder after 2 minutes of inactivity. WHEN IN SLEEP MODE 1 2 3 or In sleep mode To get out of sleep mode set to OFF ( ), then Auto On ( ) Insert paper PRODUCT MAINTENANCE OILING SHREDDER All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin. FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE 1 2 3 Set to OFF ( ) *Apply oil across entry Set to Reverse ( ) for 2-3 seconds *Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250 Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers. TROUBLESHOOTING 15 Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will .not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder. Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding. Remove Paper: When illuminated, set to reverse ( ) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry. SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate and the shredder will stop shredding. If SafeSense® is active for 3 seconds, the shredder will automatically turn off and the user must set the switch to OFF ( ), then Auto On ( ) to resume shredding.