Fellowes 90S Manual - Page 3

BASIC SHREDDING OPERATION Continuous operation: 25-minute maximum NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 25-minutes will trigger 40-minute cool down period. PAPER OR CD/CARD 1 2 Plug in and put disconnect power switch in ON (I) position Press ( ) ON to activate (blue) 3 18 4 or 18 Feed paper straight into To shred CDs rotate paper entry and release CD flap into place PRODUCT MAINTENANCE Cleaning Auto-Start Infrared Sensors Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run even if there is no paper present. (Note: two paper detection sensors are located in the center of the paper entry). TO CLEAN THE SENSORS 1 2 18 34 4 18 5 6 18 Hold CD/card at edge, When finished feed into CD/Card flap shredding set entry and release to OFF ( ) Turn off and unplug shredder Locate Auto-start infared sensor TROUBLESHOOTING Dip cotton swab in rubbing alcohol A B C D Using cotton swab, wipe away any contamination from the paper sensors A. Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder. B. Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding. C. Bin Full: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36053. D. Remove Paper: When illuminated, press reverse ( ) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry. LIMITED PRODUCT WARRANTY Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of additional costs incurred by Fellowes to provide parts or services outside of the country where the defects in material and workmanship and provides service and support for 2 years from the date shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION be free from defects in material and workmanship for 5 years from the date of purchase by the TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable original consumer. If any part is found to be defective during the warranty period, your sole and for any consequential or incidental damages attributable to this product. This warranty gives you exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product except where different limitations, restrictions, or conditions may be required by local law. For usage standards, shredder operation using an improper power supply (other than listed on the more details or to obtain service under this warranty, please contact us or your dealer. label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any 3