Fellowes DS-1 Manual - Page 4

Operation, Troubleshooting, Maintenance, Warranty - parts

Page 4 highlights

OPERATION PAPER Continuous operation: 5 minute maximum NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 4-5 minutes will trigger 20-minute cool down period. Set to Off CARD Press Auto-On ( ) Feed into paper entry and release Set to Off Press Auto-On ( ) Hold credit card at edge Feed into card entry and release TROUBLESHOOTING Paper jam: Set to Off and empty basket. Replace basket and follow any or all of the below procedures. Shredder doesn't start: Yellow - SafeSense® active Press and hold Reverse (R) Alternate slowly back and forth Set to Off ATTENTION: If the SafeSense® light remains on, you must engage the SafeSense® feature. (See SafeSense® instructions below.) Yellow flashing - SafeSense® not active Make sure control switch is in Auto-On ( ) position Pull uncut paper from paper entry Press and hold Reverse (R) Clear paper particles covering magnetic safety interlock Wait 20 minutes for red light to turn off Override Switch in order to perform steps above. Once the jam is cleared, reset the SafeSense® paper jam: If the SafeSense® feature activates (SafeSense® light remains on) to cause the user to think the shredder has jammed when it has not, use the Override Switch to deactivate the SafeSense® feature and clear the paper. Warning - when switch is in override position, the SafeSense® light will flash and the SafeSense® feature will NOT function. Once the paper is cleared, reset the SafeSense® feature. Sensor light illuminated-paper jammed SafeSense® override switch MAINTENANCE Active Not active Run regularly in reverse for one minute Oil when bin is full, or immediately, if: • Capacity decreases • Motor sounds different, or Shredder stops running Follow oiling procedure below and repeat twice. Set to Off *Apply oil across entry Press Auto-On ( ) Shred one sheet *Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250/3505006 Press and hold Reverse (R) 2-3 seconds WARRANTY LIMITED WARRANTY Fellowes, Inc. ("Fellowes") warrants the cutting blades of the machine to be free IS HEREBY LIMITED IN DURATION TO THE APPR1O5PRIATE WARRANTY PERIOD SET FORTH ABOVE. from defects in material and workmanship for 5 years from the date of purchase by the original In no event shall Fellowes be liable for any consequential or incidental damages attributable to consumer. Fellowes warrants all other parts of the machine to be free of defects in material and this product. workmanship for 1 year from the date of purchase by the original consumer. If any part is found to This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, are valid worldwide, except where different limitations, restrictions, or conditions may be required at Fellowes' option and expense, of the defective part. by local law. This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED For more details or to obtain service under this warranty, please contact us or your dealer. WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, 3

  • 1
  • 2
  • 3
  • 4

LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free
from defects in material and workmanship for 5 years from the date of purchase by the original
consumer. Fellowes warrants all other parts of the machine to be free of defects in material and
workmanship for 1 year from the date of purchase by the original consumer. If any part is found to
be defective during the warranty period, your sole and exclusive remedy will be repair or replacement,
at Fellowes’ option and expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED
WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE,
IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE.
In no event shall Fellowes be liable for any consequential or incidental damages attributable to
this product.
This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty
are valid worldwide, except where different limitations, restrictions, or conditions may be required
by local law.
For more details or to obtain service under this warranty, please contact us or your dealer.
Continuous
operation:
5 minute maximum
NOTE:
Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
4-5 minutes will trigger
20-minute cool down period.
Pull uncut paper from
paper entry
Press and hold
Reverse (R)
Set to Off
Press and hold
Reverse (R)
Run regularly in reverse for
one minute
Oil when bin is full, or
immediately, if:
• Capacity decreases
• Motor sounds different, or
Shredder stops running
OPERATION
TROUBLESHOOTING
MAINTENANCE
3
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250/
3505006
Shredder doesn’t start:
Yellow - SafeSense
®
active
Yellow flashing - SafeSense
®
not active
Make sure control switch is in Auto-On
(
) position
Clear paper particles covering magnetic
safety interlock
Wait 20 minutes for red light to turn off
Follow oiling procedure below and repeat twice.
ATTENTION:
If the SafeSense
®
light remains on, you must engage the
Override Switch
in order to perform steps above. Once the jam is cleared, reset the
SafeSense
®
feature. (See SafeSense
®
instructions below.)
WARRANTY
Alternate slowly back and forth
*Apply oil
across entry
Press and hold
Reverse (R)
2-3 seconds
Shred one sheet
Set to Off
Press Auto-On (
)
Press Auto-On (
)
Hold credit card
at edge
Feed into card entry
and release
PAPER
Set to Off
Feed into paper entry
and release
SafeSense
®
override switch
Active
Not active
Sensor light illuminated–paper
jammed
SafeSense
®
paper jam:
If the SafeSense
®
feature activates (SafeSense
®
light remains on) to cause
the user to think the shredder has jammed when it has not, use the
Override Switch
to deactivate the
SafeSense
®
feature and clear the paper.
Warning
– when switch is in override position, the SafeSense
®
light
will flash and the SafeSense
®
feature will NOT function. Once the paper is cleared, reset the SafeSense
®
feature.
CARD
Press Auto-On (
)
Set to Off
Paper jam:
Set to Off and empty basket. Replace basket and follow any or all of the below procedures.