Fender 57 Champ Owner Manual - Page 7
Vacuum Tubes, Specifications, Rear Panel
View all Fender 57 Champ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Rear Panel F. Power CORD-Connect to a grounded A/C outlet in accordance with the voltage and frequency ratings specified on the information label {J} of your amplifier. G. FUSE-Protects the amplifier from electrical faults. Replace a blown fuse only with the type and rating specified on the information label {J} of your amplifier. H. SPEAKER OUTPUT-Plug-in connection for a 4Ω speaker. A 4Ω minimum speaker load must always be connected at this jack when the amplifier is ON to avoid damage to the amplifier. I. VACUUM TUBES-CAUTION: Tubes get hot! J. INFORMATION LABEL-Technical information about your amplifier is listed here. Vacuum Tubes Your new Fender® amplifier comes equipped with the highest quality tubes available, sourced from various manufacturers all over the world. Because of occasional irregularities in supply, the specific tube type used in each amplifier is subject to change without notice. When replacing output tubes, please note the specific tube markings on the original tubes factory supplied with your amplifier. For example, 6L6 output tube types used by Fender include, but are not limited to: 6L6GC; 6L6WXT; 6L6C; 6L6GE; etc. The installation of a different type may require significant adjustment by a qualified technician to avoid reduction in performance and tube life. Additionally, Groove Tubes™ sorts and tests many of our output tubes, and paints them with a color-coded label. If your amp came supplied with, for example, White-labeled 6L6WXT tubes, then a new set of White 6L6WXT tubes will be the perfect direct replacement. If you have questions or concerns, contact your Fender dealer or authorized service center. Model '57 Champ Amplifier Tube locations left to right at rear: � � � � � � �� �� �� �� � TYPE: PART NUMBERS: POWER REQUIREMENT: INPUT IMPEDANCE: POWER AMP OUTPUT: SPEAKERS: TUBES: FUSE: DIMENSIONS: WEIGHT: Specifications PR 863 8160500000 (120V~, 60Hz) 8160501000 (110V~, 60Hz) TW 8160504000 (230V~, 50Hz) UK 8160505000 (220V~, 50Hz) ARG 8160507000 (100V~, 50/60Hz) JPN 8160509000 (220V~, 60Hz) ROK 60W 1MΩ 5W into 4Ω @ < 10% THD, 1kHz One 4Ω, 8", Weber with AlNico magnet, (P/N 0077212000) One 5Y3GT, One 6V6GT, One 12AX7 F1.25AL, 250V (100-120V versions) F1.0AL, 250V (220-240V versions) Height: 13.5 in (34.3 cm) Width: 12.5 in (31.8 cm) 16.5 lb (7.5 kg) Product specifications are subject to change without notice. 8160503000 (240V~, 50Hz) AUS 8160506000 (230V~, 50Hz) EUR Depth: 7.8 in (19.8 cm) f e n d e r. c o m 7