Fender Deluxe 90 DSP Owners Manual - Page 8

8 Deluxe™ 90 DSP Amplifier Your new Deluxe™ 90 DSP amplifier delivers world-class Fender® tone and world-standard Fender® DSP technology: • 90W output power @ 4 ohms • Digital Signal Processing • 16 FX SELECTIONS • Separate FX LEVEL and TIME/RATE controls • Selectable Normal and Drive Channels with independent volume and tone controls Panel Functions • MORE DRIVE pre-amp boost for instant gain saturation and harmonically rich leads • PRE AMP OUT and POWER AMP IN jacks • 3-button FOOTSWITCH (included) enables remote activation of: (1) Channel Select, (2) Drive/More Drive, (3) Effects Thank you for choosing Fender®® -Tone, Tradition and Innovation-since 1946 A. INPUTS - Plug your guitar in here. INPUT 1 is used for normal electric guitars. INPUT 2 is a lower sensitivity input for guitars equipped with high output (active) pickups. The Normal channel controls (B-E) are operational when the CH SELECT button is out, or footswitch is off. B. VOLUME - Adjusts the loudness of the amplifier. CDE. TREBLE / MID / BASS - Adjusts the tone in the high / middle / low frequency ranges respectively. F. CHANNEL SELECT Button OUT selects the Normal channel Button IN selects the Drive channel The Drive channel controls (G-M), are operational when the CH SELECT button is in, or footswitch is on. G. DRIVE - Adjusts the distortion level. Use together with the Drive channel VOLUME control (I) to adjust the overall loudness of the amplifier. H. MORE DRIVE - Boosts the intensity and range of the DRIVE control (G). Button OUT selects the Drive channel Button IN selects More Drive channel I. VOLUME - Adjusts loudness of the amplifier together with the DRIVE control (G). J. DRIVE CHANNEL INDICATORS - Yellow LED ON Drive channel is active Red LED ON More Drive channel is active KLM. TREBLE / MID / BASS - Adjusts the tone in the high / middle / low frequency ranges respectively. N. FX LEVEL - Adjusts the level of the selected effect. O. FX SELECT - Selects the active effect. Each position defaults to a preset time/rate parameter to allow for quick auditioning of a common variation of each effect. P. TIME/RATE - Once this knob is nudged, it adjusts the interval length / modulation speed of the active effect (see next page). Q. POWER INDICATOR - Illuminates when the amplifier is ON. R. POWER - Switches the amplifier ON and OFF. S. POWER CORD SOCKET - Connect the included power supply cord in accordance with the voltage and frequency ratings listed on the rear panel. T. PRE AMP OUT/POWER AMP IN - (1) Effects Loop - Connect PRE AMP OUT to an effects device PWR AMP PRE AMP FOOT input, then connect the effects IN OUT SWITCH device output to PWR AMP IN. (2) Multiple Amps - Connect the primary unit's PRE AMP OUT to the auxiliary unit's PWR AMP IN. The primary unit is used to control all auxiliary units. (3) Recording or Reinforcement - Connect PRE AMP OUT to sound equipment's input. Both jacks use a TS (Tip-Sleeve) standard type plug for connections. PRE AMP OUT includes onboard tone shaping and DSP effects processing. U. FOOTSWITCH - Connect the 3-button Fender® footswitch (included) to this jack to enable remote switching of CH SELECT, DRIVE/MORE DRIVE, and EFFECTS. When plugged in, the footswitch overrides the corresponding panel controls. www.f e n d e r.com ✧ www. m r g e a r h e a d .net