Fender MXA1 Owner Manual - Page 1

HP2 Personal Headphone Amplifier Thank-you for purchasing the PreSonus® HP2 headphone amplifier. Designed for musicians and performers who demand mobility without compromising audio quality, the PreSonus HP2 stereo personal headphone amplifier is a great choice for driving wired in-ear monitors (IEMs), as well as headphones. The HP2 outputs the left input to the left headphone, and the right input to the right headphone. In Mono-Mix Mode: Left and right inputs are mixed and output to both headphones. The "pan" control will adjust the volume ratio between the channels. We appreciate the support you have shown us through the purchase of this product. Rear Panel Connections and Controls Features: • 2 XLR (F) Input Connections (via included stereo cable) • Stereo 1/8" Headphone Connector • Level and Pan Control • Battery Life Indication • Included Power Supply • Sturdy Belt-Clip • 5/8" Microphone Stand-Mount Socket Precautions: Using this item at high volume levels may cause hearing damage. Adjust volume so that you may hear sufficiently. Ringing in the ears may indicate that volumes levels are adjusted too high. What's in the Box? • HP2 Headphone Amplifier • Stereo Input Cable • Power Supply • 3/8" to 5/8" Microphone Stand Adaptor Front Panel Connections and Controls 1 3 2 ➊ Power Switch. Switches the HP2 on or off. ➋ DC Input Jack. Allows connection of the DC power supply. When a battery is installed in the unit, it is switched off as soon as the external power supply is connected. When the power supply is removed the unit will again run on battery power. ➌ Input Connector. Allows connection of the 5-pin, mini XLR end of the supplied input cable. The opposite end of the input cable provides two female XLR jacks to connect to a source. Operation Modes: Stereo Operation Band Mix (L) Band Mix (R) Band Mix (R) Band Mix (L) 2 3 4 5 1 ➊ 1/8" Stereo Headphone Output: Tip = Left Signal, Ring = Right Signal, Sleeve = Ground ➋ Battery Indicators. These two LEDs indicate battery health. With a new battery at full power, only the green LED will illuminate. When battery power drops below 7.3V, both the green and red LEDs will illuminate. When 6.5V or less remain, only the red LED will illuminate and the battery should be replaced. Note: When using the DC power supply, the green LED will always illuminate. ➌ Volume Control. Adjusts the level of the headphone output. ➍ Pan Control. In Stereo Mode: Adjusts the balance between the left and right channels.In Mono-Mix Mode: Adjusts the volume ratio between the left and right channels. ➎ Mode Switch. In Stereo Mode: When connected to a stereo source, engage Stereo Mode. This will send the Left and Right input signals to their corresponding headphone output channels. While Stereo Mode is active, the pan control will adjust the stereo balance. Mono Operation Band Mix 1 Band Mix 1 Band Mix 1 When connecting to a mono source, you can connect to either the Left or the Right input. Engage the mono switch and turn