Fisher and Paykel OR36SCG4R1 Installation Guide - Page 27
Adjusting the lower oven burner minimum
View all Fisher and Paykel OR36SCG4R1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
GAS CONVERSION (GAS GAS MODELS ONLY) Adjusting the lower oven burner minimum 1 Turn on the burner by setting the oven dial the highest temperature setting. 2 Remove the dial and unscrew the by-pass screw A about three times by passing a small flat screwdriver (Ø1/8" (3mm) blade, 3 15/16" (100mm) length) through the panel opening. 3 Re-mount the dial and let the oven heat up for about 10 minutes, then bring the dial to the lowest temperature setting. to operate the thermostat by-pass. 4 Remove the dial again. Taking care not to turn the tap rod, slowly screw the by-pass screws A until you obtain a flame of 1/8-5/32" (3-4mm) in height. A The flame should not go out even when passing suddenly from maximum to minimum flame. NOTE: For LP/PROPANE gas the by-pass screw must be fixed thoroughly. 27