Fisher and Paykel WA37T26G User Guide - Page 5
Installation Instructions
View all Fisher and Paykel WA37T26G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Installation Instructions US Before you begin - read these instructions completely and carefully. WARNING Electric Shock Hazard Read and follow the IMPORTANT SAFETY INSTRUCTIONS outlined in this User Guide before operating this appliance, pages 11 - 13. Failure to do so can result in death, electric shock, fire or injury to persons. Important! Observe all governing codes and ordinances. Installation Requirements Location Your washer must be installed on firm flooring to minimize vibration during spin cycles. Concrete flooring is best, but wood base is sufficient providing the floor support meets FHA standards. Your washer should not be installed on rugs or exposed to the weather. Plumbing Water Temperature Your cold water should not exceed 95˚F (35˚C) or your hot water exceed 150˚F (65˚C). Temperatures above this may damage your washer. Shut Off Valves Both hot and cold shut-off valves (faucets) should be available in the laundry area. Drain Water may be drained into a standpipe or set tub. The standpipe must be 1½" (38mm) minimum interior diameter and must be open to the atmosphere. Electrical This appliance must be supplied with 110V - 120V, 60Hz electrical supply and connected to an individual, properly grounded branch circuit, protected by a 15 or 20 amp circuit breaker or time delay fuse. 5