Fluke 700RG08 Product Manual - Page 16

700G Series Users Manual Operation The subsequent sections tell you how to operate the Product. Push  to turn on the Product. The analog bar graph at the bottom of the display shows the applied-pressure level relative to the full range of the gauge. Note If you record a Tare value, the pressure shown is not the actual pressure applied. How to Setup the Product Before you use the product, it is necessary to configure it for your application. Push  to go to the Setup menu. Each time  is pushed, the display goes to the subsequent function. Push  or  to change the parameter value. When a parameter is set, push  to exit the configuration menu or  to move to the next parameter. Engineering Units The Product's default engineering unit shows psi. To change this, push  and  to move through the 23 standard engineering units plus one custom unit/scale. When the necessary unit shows, push  or . Pressure now shows in the chosen engineering units. See the Specifications section for a list of available 8 engineering units. See the Supervisory Mode section for instructions to set up custom units. Set Auto Off Auto Off can be set in 1-minute increments from 1 to 30 minutes or you can turn off the function for continuous Product operation. The Product is configured for 30 minutes. Push  and  to set the necessary interval. The "off" position is at the low end of the selections, less than 1 minute. Show Battery Voltage Actual battery voltage and a percent-of-life bargraph show the battery charge. No adjustments are made in this parameter. Display Actual Temperature The Product is temperature compensated This parameter shows the temperature measured by the internal sensor. Push  or  to show degrees F or C. Set Damping Selections are "on"  and "off" . Damping smooths readings from pulsating pressure sources.