Foxconn A76ML-K 3.0 English Manual. - Page 41

3 DRAM Timing Configuration CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc. DRAM Timing Configuration DRAM Timing Configuration Memory Speed Mode DRAM Timing Mode [Auto] [Auto] Help Item Options Auto Limit Manual Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help F9:Optimized Defaults ► Memory Speed Mode This item is used tu enable/disable provision of DRAM timing by SPD device.The Serial Pres ence Detect (SPD) devise is a small EEPROM chip,mounted on a DDR3 memory module.It contains inportant information about the module's speed,size,addressing mode and various other parameters,so that the motherboard memory controller (chipset) can better access the memory device. Select [AUTO] for SPD enable mode. Select [Limit], the DRAM speed will not exceed the specified value listed in the "Memory" Select [Manual],then DRAM speed is manually selected according to the set value of "Memory Speed Adjust". ► DRAM Timing Mode When both DCTs (DRAM controller) are enabled in unganged mode, BIOS must initialize the frequency of each DCT in order, you also can configure the timings manually. Settings are : [Auto], [DCT 0], [DCT 1], [Both]. 34