Foxconn A9DA-S English Manual. - Page 35
► CPU-NB HT Link Speed - unlocking
View all Foxconn A9DA-S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Fox Intelligent Stepping CMOS Setup Utility - Copyright (C) 1985-2006, American Megatrends, Inc. Fox Intelligent Stepping CPU Clock Current CPU Speed [200] :3000MHz Help Item CPU Multiplier Adjust Current FSB Multiplier [Auto] :15x CPU-NB HT Link Speed [Auto] Current FSB/HTT Speed :2000MHz Memory Speed Mode [Auto] Current DRAM Speed :800MHz, N/A GFX Engine Clock Override [Disabled] PCI Express Clock [100] Spread Spectrum [Disabled] 3 Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help F9:Optimized Defaults ► CPU Clock This option is used to adjust the CPU clock. ► Current CPU Speed This item displays the current CPU speed. ► CPU Multiplier Adjust This option is used to adjust the CPU Clock Ratio. Multiply CPU clock with this ratio, you can get the CPU speed. Increase this ratio may overclock your CPU. This option will be valid if your CPU ratio is unlocked and will be displayed only if your CPU is supporting this feature. ► Current FSB Multiplier This item displays the current FSB Ratio. ► CPU-NB HT Link Speed HT stands for HyperTransport bus. The CPUNB HT Speed option controls the physical speed of the CPU to Northbridge HT link using multipliers ranging 1x to 13x. The physical speed of the link is determined by multiplying the CPU FSB with the CPUNB HT Speed setting. ► Current FSB/HTT Speed This item displays the current Front Side Bus speed. ► Memory Speed Mode This item is used to enable/disable provision of DRAM timing by SPD device. The Serial Presence Detect (SPD) device is a small EEPROM chip, mounted on a DDR3 memory module. It contains important information about the module's speed, size, addressing mode and various other parameters, so that the motherboard memory controller (chipset) can better access the memory device. Select [Auto] for SPD enable mode. Select [Limit], the DRAM speed will not exceed the specified value listed in the "Memory Speed Adjust" item. If SPD value is faster than "Memory Speed Adjust" value, it will run at the specified "Memory Speed Adjust" speed. Otherwise, SPD value is selected. Select [Manual], then DRAM speed is manually selected according to the set value of 28