Foxconn G31M English Manual. - Page 26
Over Memory Frequency Jumper: JP1, JP2
View all Foxconn G31M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
2 WARNING! ■ Disconnect the power cable before adjusting the jumper settings. ■ Do not clear the CMOS while the system is turned on. Over Memory Frequency Jumper: JP1, JP2 When you use the memory which support 1066, the jumpers are used to overclock memory frequency. At the same time, the overclock bound depend on CPU FSB, you can achieve the function as below. 1. When the CPU FSB is 1066MHz, set the JP1 pins to 2-3 (as Status 1) , and set "CMOS Setup" -> "Fox Central Control Unit" ->"DRAM Configuration" -> "DRAM Timing Selectable" to "Manual", "System Memory Speed" will show 886 and 1066. 2. When the CPU FSB is 1333MHz, set the JP2 pins to 2-3 (as Status 2) , and set "CMOS Setup" -> "Fox Central Control Unit" ->"DRAM Configuration" -> "DRAM Timing Selectable" to "Manual", "System Memory Speed" will show 1000. Default Status 1 Status 2 JP1 1 1 1 JP2 1 1 1 19